I'm Using LibreCAD 2.0.9.I tried the Concentric Circle but the Distance and Number field didn't display in the tool area and the Distance defaulted to 1. In the Command Line area it says this:"Specify Distance or select entity or [through]"I was going to try typing in a command line code but I don't think Concentric Circle has a command line code according to this manual:wiki.librecad.org/index.php/A_short_manual_for_use_from_the_command_line
+jh I am currently using version 2.0.2., it does not bring up the distance in the tool area either. I have not had a reason to use concentric circle lately so I did a little testing and came up with a "work around". If you go to the line lines toolbar from the main toolbar and then click parallel line it will give the distance and number field. If you go near a circle it will draw a concentric circle. Yeah it is a backdoor way to "git er done"... but almost every software I have ever used has some kind of problem like this. I am sure they are fixing it but until then this will get it done.
Je voudrais pouvoir aider à la française. Malheureusement, je ne connais que l'anglais. Je dois la possibilité d'ajouter des sous-titres en différentes langues si quelqu'un veut traduire et ajouter des légendes. (Espérons que cela se traduit correctement. -- Google Translate.)
![ILLSLICK - KILLSHOT REMIX [FULL VERSION]](http://i.ytimg.com/vi/RIK8RrqIAzE/mqdefault.jpg)
I'm Using LibreCAD 2.0.9.I tried the Concentric Circle but the Distance and Number field didn't display in the tool area and the Distance defaulted to 1. In the Command Line area it says this:"Specify Distance or select entity or [through]"I was going to try typing in a command line code but I don't think Concentric Circle has a command line code according to this manual:wiki.librecad.org/index.php/A_short_manual_for_use_from_the_command_line
+jh I am currently using version 2.0.2., it does not bring up the distance in the tool area either. I have not had a reason to use concentric circle lately so I did a little testing and came up with a "work around". If you go to the line lines toolbar from the main toolbar and then click parallel line it will give the distance and number field. If you go near a circle it will draw a concentric circle.
Yeah it is a backdoor way to "git er done"... but almost every software I have ever used has some kind of problem like this.
I am sure they are fixing it but until then this will get it done.
Je voudrais pouvoir aider à la française. Malheureusement, je ne connais que l'anglais. Je dois la possibilité d'ajouter des sous-titres en différentes langues si quelqu'un veut traduire et ajouter des légendes. (Espérons que cela se traduit correctement. -- Google Translate.)