It seems to detect the highest ‘safe’ amps to send to the battery on the fly. It’s out of our control. The 5A setting is your max and it’ll go up and down if you watch it.
@@netcruzer , it goes up to a max A depending on the voltage of the pack, but limited by the Watts on a specific channel of the charger... so 50W, 100W, 130w, 200w.... you have to take the wattage, divide by max voltage of a pack(8.4A, 12.6A, 16.8A, 25.2A, etc)... I'm "charger shopping" myself lately a bit... I have the very similar 2ch Hitec, not sure who makes them for who, but there are a handful of units out there which are eerily similar... I am looking into the T200 right now...
Can you check how much battery is left with this charger? I’m using a Loop battery atm but I can’t figure out how to check how much battery is left in them.? Thanks!
@@netcruzer Do you know where I can get tech support for this device? I have the one plug LiPo batteries. I hooked one up to the a port and I got a message that no battery was found. Just got it from banggood.
![[開箱報告] 充電工廠再打造- SkyRC Q200Neo四通道輸出充電機](/img/n.gif)
The Canadian in me immediately recognized the Canadian in you 😁😁😁😁🇨🇦🇨🇦👌
Great vid review. Do you still use this or did you upgrade to another one?
Thanks for your time i appreciate it.
By 2:51 I had heard enough and bought one. Thanks
Pb is lead acid batteries, your normal start-light-ignition battery in the car
hi, if i want to feed it with a 12 volt car battery, how many maximum amperals does it have to have? thanks for the reply
Hi, I just got the D100 v2. And just like your charger it doesn’t go to 5amps on 4S. It stays on 3,2. Don’t you thing that’s odd?
It seems to detect the highest ‘safe’ amps to send to the battery on the fly. It’s out of our control. The 5A setting is your max and it’ll go up and down if you watch it.
@@netcruzer That was my question to. 5ah is not 3.2ah
@@netcruzer , it goes up to a max A depending on the voltage of the pack, but limited by the Watts on a specific channel of the charger... so 50W, 100W, 130w, 200w.... you have to take the wattage, divide by max voltage of a pack(8.4A, 12.6A, 16.8A, 25.2A, etc)... I'm "charger shopping" myself lately a bit... I have the very similar 2ch Hitec, not sure who makes them for who, but there are a handful of units out there which are eerily similar...
I am looking into the T200 right now...
Can you check how much battery is left with this charger? I’m using a Loop battery atm but I can’t figure out how to check how much battery is left in them.?
Thanks!
It shows you a bar graph percentage as soon as you start charge or discharge. Or you can check each cell voltage too.
Thanks man! Good video and good help
@@netcruzer How long would it take to charge a 7.4v 2800mAh battery?
You set battery A to charge at 5amp was the charger able to charge at 5amp
Yes
Netcruzer RC TECH CARS Looked like it was only charging at 3.2A...
I agree it was only charging at around 3.2amps for some reason.
Can you charge a battery directly from the balance boards?
No I don’t think so. That would be trickle slow even if you could.
@@netcruzer Is there tech support for this device. I have the one plug LiPo batteries and I'm getting a no battery found message.
Hi, like to know can we charge 2 nos 6S 5000mah and 2 nos 3S 2200mah at same time. Thanks.
whats nos? But yes you can charge two 6S and two 3S of different capacities at the same time at a full 1C or more charge rate with those capacities.
@@netcruzer Do you know where I can get tech support for this device? I have the one plug LiPo batteries. I hooked one up to the a port and I got a message that no battery was found. Just got it from banggood.
@@spirittoo just use 'charge' not 'balance charge' should work just fine
Other than the color it is exactly the same as my Hitec 4X.
just like my Hitec 4X.