Yaskawa GA500 VFD, remote control, MOP speed control, Multi frequency set up. English

Yaskawa GA500 VFD, remote control, MOP speed control, Multi set frequency set up. For manuals, parts and related videos, please see below.
Yaskawa GA500 VFD CIPR-GA50CB002EBAA: www.ebay.co.uk/itm/333868811530
Yaskawa GA500 Tech Manual: www.yaskawa.com/delegate/getA...
Yaskawa GA500 Quick start Guide: www.yaskawa.com/delegate/getA...
Yaskawa GA500 Core manuals, including transition from J1000 to GA500: www.yaskawa.com/products/driv...
Website: igselectronics.co.uk/
eBay store: www.ebay.co.uk/str/igselectro...
Yaskawa GA500 VFD, local run, Commissioning, Auto Tune, Parameter set up Factory reset: • Yaskawa GA500 VFD, loc...
Yaskawa GA500 VFD, remote control, 2 wire control, 3 wire control, remote speed control: • Yaskawa GA500 VFD, rem...
Run a 3 phase motor on single phase power, basics: • Run a 3 phase motor on...
Single phase to 3 phase VFD drive home setup: • Single phase to 3 phas...
Single Phase / Tree Phase Inverter 3 Wire Control Station: igselectronics.co.uk/products...
Single Phase / Tree Phase Inverter 2 Wire Control Station: igselectronics.co.uk/products...
Multi frequency control Station: igselectronics.co.uk/products...
MOP/Electronic Control Station: igselectronics.co.uk/products...

[@sssssssssggggggg]

Late in the day Ingus - but you have saved my life. Thank you. I have a 22kw motor that needed to ramp up to 50HZ in 30 seconds.
The load is heavy until full speed and no matter what I did - the drive tripped with OL/2 fault (over current for too long)
I read the manual for multi speeds and it was defeating me. Your explanation and demo showed me how.
I programed the speed sequence into a plc and paused between each ramp-up to allow the Amps to come down (65A down to 17A)
It now reaches full speed with no OL messages. Thanks again.

[@sajek4246]

well done 👌

[@IFoundThisNow]

Hello Over there :)
I wish that u make a video about using 2 different decelerations and accelerations, and use them for a 2 speeds.
Regards

[@josecarlosfranca6397]

Se fala em português seria mais facil

[@IGSElectronics]

Mas eu não sinto muito

[@lucasrramenda]

O cara é Americano.

[@user-lx6mv7wb5q]

Realy ! u do an afaviur to me ! Thanks allot