It depends on the cause of the misfire. You wouldn’t replace the motor if it’s just an ignition problem. If it’s a valve train , or piston issue, then maybe so.
There are a couple of lines that have to be extended and a SRV controller has to be added. I have a video where I recap the installation and talk about everything needed except for the SRV controller. I added it later after finding out that the lockout plate robbed me of 30hp.
That's without the exhaust hooked up? It sounds beast!!!!
Ello Beastie!
I have a 2012 citadel with a 5.7 had misfire cylinder 5 I was curious if this is worth doing or just go with 5.7
It depends on the cause of the misfire. You wouldn’t replace the motor if it’s just an ignition problem. If it’s a valve train , or piston issue, then maybe so.
Was the wiring harness plug and play? Or some slight wiring was needed
There are a couple of lines that have to be extended and a SRV controller has to be added. I have a video where I recap the installation and talk about everything needed except for the SRV controller. I added it later after finding out that the lockout plate robbed me of 30hp.
I have a 2014 Durango could i swipe it with the Hemi ?
Yes, most anything can be swapped. Much more difficult if you’re starting with a V6 though.
What's the suspension ?
Eibach pro kit
With the z automotive srv harness do you still have to tap into the injector wiring? I’m confused on that part with the 6.4 manifold swap
No. Power from the fuse box, ground and it hooks to the star connector point. Easy pezy.
Here’s a link to the instructions with pictures.
www.modernmusclextreme.com/images/media/p-1503-SRV_Controller_User_guide.pdf
Did a complete swap and the truck won’t start only throws a bunch of codes
And says no bus
Oh no. What vehicle and what motor?
@@tonyharmsen5081 ok got a question….can I use my PCM from my original 2013 5.7 Hemi?
I have swapped a 6.4 motor and trans from a 2018
I don’t think that is compatible. Dodge changed the system in 14 to the current set up. I don’t know what you would need to make it work. Sorry