Mountain Snow and Sleet TESTED Redi-Plow Snowsport Plow - Part 2

[@jclarkj6]

Just added to my ‘23 Tacoma.
10” from push frame to ground.
Could flip attach plate but I’m on level ground.
Thx!

[@SouthMountainHomestead]

Thanks for sharing that information. Looking forward to a snowy winter!

[@EddyPENN-4]

Thanks!!!

[@SouthMountainHomestead]

You are welcome!

[@kelsey809]

😊👍
Hello! Is the bottom of the push frame 8” from the ground? It kinda looks like the plow isn’t flopping down very much when you reverse. Have a nice day!

[@SouthMountainHomestead]

Great question! I just went out and measured and it's a little higher than that. I have the push frame set up using the lowest setting, so it's as low as it can go on my truck. Thank you again!

[@kelsey809]

Cool. I have a Tacoma as well, same setup, Curt receiver too. We installed the pushframe and it was too high so we took off the vertical bars from the input piece and flipped that input piece so the angle to the mounting plate is downward and reattached the vertical bars. If that makes sense. 🤷🏻‍♂️ I really needed the push frame at 8” to plow the crests of hills. Have a nice day! 😊

[@kelsey809]

We did what this guy figured out.
m.th-cam.com/video/XH0-lAU-e6A/w-d-xo.html&pp=ygUec25vd3Nwb3J0IGhkIHV0aWxpdHkgc25vdyBwbG93

[@kelsey809]

m.th-cam.com/video/XH0-lAU-e6A/w-d-xo.html&pp=ygUec25vd3Nwb3J0IGhkIHV0aWxpdHkgc25vdyBwbG93

[@SouthMountainHomestead]

Great information! Thank you so much for sharing! :)

[@dkat1108]

Thanks What tires you using on your truck they seem to be working pretty good ?

[@SouthMountainHomestead]

Thanks for your question. They are General Grabber AT2 at the factory size. I've been happy with them. Thank you again!