what are/did you putting this 242 into? What yoke is on it for front drive shaft. Am re-newing one to go in a 5speed TJ. Am changing to longer trans input out of 231. Got suggestion on what to do with front driveshaft? It has the more typical yoke on it and not the Rzepa.yoke.. but been told the 231 yoke and the 242 yoke... while look same.... they aren't (part #'s support that too)
factory case on my zj. not sure about the yoke its whatever 1310 yoke is original to the case. Im guessing the yoke difference in p/n maybe a length thing, other than that the driveshaft should be interchangeable between yokes. I use custom shafts from Adams driveshaft in vegas
Probably a dumb question, but how did you remove the slip yolk off the rear of the shaft? Driveshaft blew off today because of a bad u-joint and I need to remove it to press the u joints out and I can’t get it to budge
what are/did you putting this 242 into? What yoke is on it for front drive shaft. Am re-newing one to go in a 5speed TJ. Am changing to longer trans input out of 231. Got suggestion on what to do with front driveshaft? It has the more typical yoke on it and not the Rzepa.yoke.. but been told the 231 yoke and the 242 yoke... while look same.... they aren't (part #'s support that too)
factory case on my zj. not sure about the yoke its whatever 1310 yoke is original to the case. Im guessing the yoke difference in p/n maybe a length thing, other than that the driveshaft should be interchangeable between yokes. I use custom shafts from Adams driveshaft in vegas
Probably a dumb question, but how did you remove the slip yolk off the rear of the shaft? Driveshaft blew off today because of a bad u-joint and I need to remove it to press the u joints out and I can’t get it to budge
it should just slide right off.