RAMPS 1.4 - Stepper Driver Intermediate

This is a basic tutorial on how to configure your Marlin Firmware for X/Y/Z steppers.
One Time Tips, You Can PayPal Me:
www.paypal.me/EBraiman
Discord:
/ discord
Patreon:
/ edbraiman
buymeacoffee:
www.buymeacoffee.com/ebraiman

[@4ngelk1ng]

Hello again Can I ask a question ? I got step drivers. Model is micro steps shs 39/400 It is 24V 0.4A 21 Ohm Can I use with ramps

[@EdwardBraiman]

I'm guessing it possible to use, but my experience level with 24v stepper motors is not up to giving advice yet. I'm only running 12 volts in my current configurations. You might want to check the RepRap forums to see if someone has already attempted this. Here is the link ... forums.reprap.org/ .. hope this helps.

[@hopeful1521]

thank youuuu

[@EdwardBraiman]

You're welcome.