Really good. Thank you. Soooo. Could I double-check? To make sure I understand this correctly, as my tick box is already unticked. What about re-zeroing the machine to the work piece? For example, if I did a complete controlled shut down (yellow Feed Hold button then the red Stop button), made a note of the g-code line where it stopped. Shut the whole lot down. ...........Come back the following morning. Load the g-code, find the g-code line then 'Run From Here'. Would the work piece 'zero' position be saved as part of this technique? I.E. would I need to worry about re-zeroing? Is your 'offsets' the same as my 're-zero my work piece'?
![[TH] FS vs BME - VCT Ascension Pacific - Lower Bracket Final](http://i.ytimg.com/vi/wnygqsR2Fig/mqdefault.jpg)
Too bad you didn't do a vid to save g53 in M4. When we shut down the machine coord dros get zeroed next session. Its an awful "improvement"
I've never used Mach4 so I can't help sorry.
Thank you
It was very good, could you re-do it in the English Language?
Very educational; Thank you, I learned a few things on this.
Bom dia o significa fixture sabe, obrigado.
I was doing this but wasn't quite sure how it was configured. Thanks for the lesson. Cheers
plz send router.xml
thanks
Really good. Thank you. Soooo. Could I double-check? To make sure I understand this correctly, as my tick box is already unticked. What about re-zeroing the machine to the work piece? For example, if I did a complete controlled shut down (yellow Feed Hold button then the red Stop button), made a note of the g-code line where it stopped. Shut the whole lot down. ...........Come back the following morning. Load the g-code, find the g-code line then 'Run From Here'. Would the work piece 'zero' position be saved as part of this technique? I.E. would I need to worry about re-zeroing? Is your 'offsets' the same as my 're-zero my work piece'?
Yes. The G54 is saved. You home the machine and your workpiece should be already set as per it was before shutdown.