Can't speak to the way that he did it but what I did was take a steel tube that was a snug fit over the hoverboard motor and drill a hole in the side of the tube. You could either directly tap that hole for a set screw or do what I did and weld a nut to it. you can slide the hoverboard motor in (you'll have to remove the connector it came with) and then tighten down the set screw onto the flat side of the shaft. Held up just fine so far. I used a 3/8th dia bolt (~9 mm) for the set screw.
depends on battery voltage and controller design. Vescs with phase weakening and higher voltages (I believe stock is 36 v) can enable higher top speeds.
Hello, nice video, how did you do to find the exact center of the hub to make the 3 drillings ? Thanks.
Careful measurement 😉 I aligned both exactly before drilling.
nice work👍
Controller? 36v 350w? 13A?
how fast do the Scooter go
@@thomas1000official Top speed is roughly 8 - 10mph 👍
@@robmakes8824 it look fun
Brother I have a doubt . How u done back & front wheel mounted method I can't understand please reply me
Can't speak to the way that he did it but what I did was take a steel tube that was a snug fit over the hoverboard motor and drill a hole in the side of the tube. You could either directly tap that hole for a set screw or do what I did and weld a nut to it. you can slide the hoverboard motor in (you'll have to remove the connector it came with) and then tighten down the set screw onto the flat side of the shaft. Held up just fine so far. I used a 3/8th dia bolt (~9 mm) for the set screw.
How do you cut power to the motor while the brake is being applied?
By releasing the throttle 😉
How did he secure the wheel shaft in the frame?
I make a custom bracket at 3:01👍
*Cool ce frein à disque.*
Nice work tho your brake discs is as big as your wheels 😉 slight overkill as the top speed of a segway wheel is around 10-12mph right?
good luck finding a smaller disc brake
depends on battery voltage and controller design. Vescs with phase weakening and higher voltages (I believe stock is 36 v) can enable higher top speeds.
What is the size of your disc brake?? Pleass reply. Thank you!
Yes please reply
Standard mountain bike rear disc and front calliper, front disc was too wide 👍
@@robmakes8824 disc size (110mm -140mm)
Nice bro!
The best 💪👍👍👍
i think the disk is to big , im planing to do this and use bandbrake
Very nice. By the way your twin motor hoverboard e bike has torque for uphills
👍
Я на такие колеса ставил без камерную покрышку 85/75-5"
Excellent 👍
Noce build new frnd her bro
That looks like a recipe for pain. Lock up that little 6.5" wheel and it becomes a perfect pivot to throw you into the ground.
Which is why you crouch and lean back as you brake
Ride safe all 😉
Вся конструкция как на соплях! Без обид бро!