Thank you so much .. I was looking for this tutorial in the whole off the TH-cam couldn’t find any .. sourcing from other shop was costing me a lot and if I go to our Local Miter 10 I can show it to them and buy and get it prepared in a very cheap price. Thanks again
I wouldn't make it any wider, because if it's any wider, the picture would be leaning too much. But if you needed to, I suppose you could just move your fence over the width of a saw blade and run it over again, making the slot 2 blade widths. You could continue this to get your desired width.
Thank you so much .. I was looking for this tutorial in the whole off the TH-cam couldn’t find any .. sourcing from other shop was costing me a lot and if I go to our Local Miter 10 I can show it to them and buy and get it prepared in a very cheap price. Thanks again
It looks like it's been a while since you uploaded anything new. Came by to support the small channels. Keep up the good work.
I would lightly stain them or just clear coat them.
can you make it with sliding mitter saw or angle grinder ? show us alternative method without using table saw
What is the angle of the blade?
Sir..could you pls name the wood used
he did...oak...and what a waste of good oak that was
What’s the dimensions of your table?
How would you make a slot wider ?
I wouldn't make it any wider, because if it's any wider, the picture would be leaning too much. But if you needed to, I suppose you could just move your fence over the width of a saw blade and run it over again, making the slot 2 blade widths. You could continue this to get your desired width.