How to remove the RH dash end trim & light switch on 2006 Range Rover L322

แชร์
ฝัง
  • เผยแพร่เมื่อ 12 ธ.ค. 2024

ความคิดเห็น • 15

  • @mukwera9131
    @mukwera9131 5 ปีที่แล้ว +1

    Brilliant video - well done - highly informative and down to earth.

  • @flemmingranch8777
    @flemmingranch8777 7 ปีที่แล้ว

    Rigtig god instruktion for hvordan man skiller tingene ad og skifter pære. Rigtig godt........

  • @douvenouart
    @douvenouart 11 หลายเดือนก่อน

    Hello, I am grateful for the good suggestions. Where is the module (control module) for the headlights located? Thanks so much.

  • @christopheracquart7219
    @christopheracquart7219 2 ปีที่แล้ว

    Great video, how do I disconnect the electric connectors on the air vent

    • @L663
      @L663  2 ปีที่แล้ว

      From memory they are just a pull but i cannot remember 100%

  • @510bronson
    @510bronson 2 ปีที่แล้ว

    How do you get the obd 2 port trim off ??

  • @sharafooniful
    @sharafooniful 3 ปีที่แล้ว

    Where is your shop. I need end trim replacement and I can drive to your location if that is OK.

  • @MomenSalameh
    @MomenSalameh ปีที่แล้ว

    Hello i need an advice please, i have the entire left side indicators not functioning, and have the U0183 error on my scanner, but i dont know where is the LCM located or how to reach it on Range rover sport 2007 3.6 tdv8 diesel, would you please advise? thanks

    • @L663
      @L663  ปีที่แล้ว +1

      There does not seem to be a lot about this faul.
      Some ideas - disconnect battery and leave 10 mins then reconnect - this should reset all the ECU's
      swap the LH and RH light unit over - rest them on the boot floor - see if the fault follows the light or the stays on the left

  • @Defender-Guy
    @Defender-Guy 5 ปีที่แล้ว

    Can you remove the headlight switch after just removing the side panel?

    • @L663
      @L663  5 ปีที่แล้ว

      Yes - it just pops out but does take a lot pf pushing - there are lots of little "fingers" around the edge that hold it in.

    • @Defender-Guy
      @Defender-Guy 5 ปีที่แล้ว

      powerfulukltd Thanks! Do you just push it out or do the clips need to be released/removed?

    • @L663
      @L663  5 ปีที่แล้ว

      @@Defender-Guy its mostly pushing but you need to help the clips a little as you push

    • @Defender-Guy
      @Defender-Guy 5 ปีที่แล้ว

      powerfulukltd Thanks, I’ll give it a try today.

  • @malcalamark5
    @malcalamark5 7 ปีที่แล้ว +1

    I hate those vent clips. They are a pain in the butt.