Spark Plugs | 2008 Triumph Sprint ST 1050

Tools needed:
5/8" Spark Plug Socket (With extension)
Magnet poking stick (If needed)
9mm Hex Bolt
8mm and 10mm socket
Stock Plugs: NGK CR9EK
Upgraded Iridium Plugs: NGK CR9EIX
Spark Plug Torque Specs:
13ft/lbs | 18nm | 159 lbf/in
Steps:
1. Seat removal ( 2x 9mm Hex bolts)
2. Luggage rack removal (4x 9mm hex bolts)
3. Fairing removal (4x 9mm hex bolts)
4. Seat hinge removal (2 8mm bolts)
5. Gas tank hung removal (1x 8&10mm bolt)
Remove 2 electrical connectors and two fuel lines
Slide gas tank back and up
6. Disconnect sensors
7.Remove air box top (multiple Phillips screws)
8. Remove air filter
9. Remove 4 bolts holding air filter on
1 up top on the airbox (8mm) two on the bottom (10mm) and 1 on the small plastic box at the top
10. Disconnect spark plug boots and remove them by pulling them up
11. Use a 5/8 Socket for spark plugs with extension to remove spark plugs.
12. Install new spark plugs (13ft/lbs)
13. Put spark plug boots back on (firm pressure). Make sure they are seated nicely.
14. Put the airbox box back on with the expansion tank
The throttle bodies will be sealed perfectly, if you see a spring sticking out of the airbox seal when you put the airbox back on, fix the seal and put the spring inside the rubber seal and push it back onto the throttle bodies.
15. Put the air filter back on
16. Close the air filter top with Phillips screws
17. Plug the electrical connectors back
18. Put the gas tank on the bike and plug the two electrical connectors and two fuel lines
THIS IS WHERE YOU START THE BIKE AND TEST IT
19. Line the tank up and out that long bolt through
20. Line the seat hinge and screw the two bolts onto the side with proper hinge angle
21. Put the fairings back in (4x 9mm hex bolts)
22. Put the luggage rack back on (8x 9mm hex bolts/ 4 per each side)
23. Put the seat back on (9mm hex bolt)
Slide the seat forward and down
How to change Triumph Sprint ST 1050 Spark Plugs
2008 triumph sprint st 1050 spark plug change
2008 triumph sprint st 1050 spark plug replacement

[@abulshah1032]

Best video I have seen to remove the air filter and replacing the plugs. Thank you!

[@bderkhanvlogs4715]

Thank you! Figured I’d make my own since none showed how to do it in every step

[@zaneplumleymotorsports6040]

Nice video, straight to the point. No blah blah blah for 10 minutes before getting to the work. Thank you for putting this together.

[@bderkhanvlogs4715]

Thank you! That’s what I was going for.
I was struggling to find a good video on how to take the tank off… decided to make one myself

[@martingecko2786]

Great video, articulation, details showed and fully explained. One of the best ST maintenance videos I've ever seen 👏

[@bderkhanvlogs4715]

Thank you! Figured I’d make a video since there’s practically none out there