NX 1953 Series - Create a Bendable Pipe with Global Shaping by Curve

In this video you can find information about the following topics:
NX 1953 Series New Sketch Interface (Dimensions and Constraints)
Studio Spline: This command dynamically creates splines using either points or poles. The options are the same as the Modeling Studio Spline command, except sketch constraints can be used to constrain pole locations and end tangency.
Intersection Curve: This command creates a smooth chain of curves where a set of tangent continuous faces intersects the sketch plane.
Add/Remove Expression: This command creates an external expression.
Tube: This command creates a single solid body by sweeping a circular cross-section along a centerline path with options for outer and inner diameter. You can create wire bundles, harnesses, tubing, cabling, or piping components with this command.
Revolve: This command creates a round or partially round feature by rotating section curves around an axis.
Pattern Geometry: This command creates patterns of the geometric objects with various options. For a Linear layout, you can specify a Symmetric pattern in one or both directions.
Unite: This command combines the volume of two or more solid tool bodies into a single target body.
Edge Blend / Feature Intersection Edge: This particular rule selects all edges produced by the intersection of a target and a Boolean tool body.
Shell: This command hollows out a solid body or creates a shell around it by specifying wall thicknesses.
Global Shaping/ By Curve: Deforms a sheet body or facet body by editing a reference curve. You select a base curve and optionally a control curve. The deviation between the base curve and the control curve determines the amount of offset that is applied to the new sheet body at any given point.

[@naveenkushwaha6305]

REALLY! a good one .thanks

[@radon3292]

Great videos! Thank you!

[@leywey0129]

Very good

[@alirezasaedi2613]

Hi, how did you make the bending movie?

[@lanyitiann]

Would be nice of you if the prt file is attached,thx

[@martinknaup7492]

Super Sache tolles Video 👍🏻
Nur der R2 der Rippe wird schon sehr stark verformt 😵‍💫

[@cengizbahar5194]

thanks, I'm going to add a different method video about it 👍🏻

[@historyoflionproudpeople6767]

nx thumbnail icon not see in my drive how to slove it ?

[@avula.vishnuvardhanvishnu5665]

how to twist solid body sir in nx

[@rajindermalhotra8977]

V goodness but do not show the cmannd

[@rajindermalhotra8977]

Please zoom tha command show all viewers