Hi It depends how the postprocessor is setup. In case of lathe mode on Okuma we don't use exact B-angle, but registered tool position. That is why UDE was used for that. There are several ways how it can be configured - and you should use it the way as it is specified in your postprocessor.
Is it possible to create multiple cutting tool & holder library?
How did you make that custom ude tool position selection?
🇵🇱
How can I do holder position setting without UDE application?
Hi
It depends how the postprocessor is setup. In case of lathe mode on Okuma we don't use exact B-angle, but registered tool position. That is why UDE was used for that.
There are several ways how it can be configured - and you should use it the way as it is specified in your postprocessor.
No write access mesg came
send me 3D model of tool.😇