Hey man good video! How did it perform after you tried it? was this squirt enough or did you have to put a stiffer spring so it would have a bigger motion so bigger squirt? My pd keeps leaking out of the overflow and doesnt pull (no power) but that has to be cause mine doent add fuel with the pump at all, so gotta fix that and now and then the leak and were set ✌🏽🔥
You're right it does need a little bit tighter spring up there to push that rod down didn't get the motion I wanted but it does work. If I remember correctly I think I did replace it with a tighter spring. But if you help it with your finger while you're turning the throttle it makes a full stroke
@@goose278 yeah i hope ill get a little further ive cursed keihin multiple times now but im getting there haha thanks again for the video i cant believe i didnt see it earlier haha 🍺👍🏼
I'm not sure which one you mean. On the low end adjustment screw, there's a small o ring inside there.The tube shaped one Might be for the accelerator pump shaft? It's been a couple of years. I can't really remember.
Hello! Do you know how long that rod was?? I bought one for a cb750. It’s the same length rod that I just took out. 89mm long. Not sure this is correct
Hey man good video! How did it perform after you tried it? was this squirt enough or did you have to put a stiffer spring so it would have a bigger motion so bigger squirt? My pd keeps leaking out of the overflow and doesnt pull (no power) but that has to be cause mine doent add fuel with the pump at all, so gotta fix that and now and then the leak and were set ✌🏽🔥
You're right it does need a little bit tighter spring up there to push that rod down didn't get the motion I wanted but it does work. If I remember correctly I think I did replace it with a tighter spring. But if you help it with your finger while you're turning the throttle it makes a full stroke
Getting Crud in those check valves was the problem most of the time but once they're clear it should work
@@goose278 yeah i hope ill get a little further ive cursed keihin multiple times now but im getting there haha thanks again for the video i cant believe i didnt see it earlier haha 🍺👍🏼
@@ferrononferro3941 👍
There is this black rubber ring seal in the repair set. Where does that belong to? And the tube shaped one as well?!
I'm not sure which one you mean. On the low end adjustment screw, there's a small o ring inside there.The tube shaped one Might be for the accelerator pump shaft? It's been a couple of years. I can't really remember.
Thanks for that fast answer :) I guess, i just wait for the perfomance and if something fails...
@@goose278
Hello! Do you know how long that rod was?? I bought one for a cb750. It’s the same length rod that I just took out. 89mm long.
Not sure this is correct
Not sure but the one on my 750 was perfect. Putting on 500 carb had to be modified if that helps
@@goose278 So that rod you modified was for the cb750 originally is what I’m understanding?? Thanks for the reply
@davidphelps3615 yes sir