Hi Ryan, I'm a Ranger BCO. My '15 T680, needs a chassis harness. I bought the harness, but can't find any dealer with time to install it. I do quite a bit of my own work. How long did it take you to do yours, start to finish?? Thanks!
Hey Ryan, you said that you replaced that engine harness on the CM 2250 but by looking at this closely it’s a CM 2350 . Can you give us the part number for it? Thanks , and great video.
Hi I have a 2019 frightliner cascadia with 390.000 miles dd15 engine the truck started jerking around 320.000 miles going down the road for 1/2 sec then goes back to normal. I initially had a problem with the camshaft position sensor. Got that changed from the dealer . Ran fine for 3 months then same problem . Changed the camshaft position sensor 3 times but it still jerks sometimes for couple of seconds now. Took it to dealer multiple times they can't find an problem . Since there are no codes. I have a little oil leak from steering fluid reservoir. And while driving with wind it spreads around sometimes where one of the wire plug is you think my engine harness is bad due to oil leak please advise Thank you!
@@truckingandfixing No lights when it jerks but ossasanly the truck does show. Performing engine shutting then I usually press override eng shutdown or take the rpm's higher. And it gives me the green check engine light and after driving for 300to 400 miles the sign goes away happend to me 3 times in last 3 months. One time it happened I took it to local mechanic . He said it showed a code for bad camshaft sensor. But how did the camshaft sensor started working again . He said your harness might be bad but after 2 days he said that he could not find anything wrong with the harness and changed the camshaft sensor. I doubt the he went thru every harness connecter and checked for correct voltage. But frightliner cannot find anything after doing dyno and taking it for test drive for 3 days
Yes, I am still with Landstar. I would advice to join our Facebook Landstar owner operator group. There are many active Landstar BCOs and they share their experience and knowledge with each other, read the video description to see the direct link to join! Good luck.
How much horsepower does you truck have and what is the gear ratio in the rear in? Looking to buy a truck and need to know your numbers. I’m from Ohio also.
![[Part 4] หนุ่มน้อยรักคุณย่ายิ่งกว่าใคร ไม่ว่าใครก็รังแกดูถูกท่านไม่ได้!! #โลกการละคร](http://i.ytimg.com/vi/sLsBxw99FR0/mqdefault.jpg)
![🔴 ฟุตบอลแชมป์กีฬา 7HD แชมเปียน คัพ 2024 [รอบรองชนะเลิศ]](http://i.ytimg.com/vi/zPm8ClLVhoE/mqdefault.jpg)
What's the part number for the harness?
Did you disconnect the batteries???
Hi Ryan, I'm a Ranger BCO. My '15 T680, needs a chassis harness. I bought the harness, but can't find any dealer with time to install it. I do quite a bit of my own work. How long did it take you to do yours, start to finish?? Thanks!
Hey Ryan, you said that you replaced that engine harness on the CM 2250 but by looking at this closely it’s a CM 2350 . Can you give us the part number for it? Thanks , and great video.
Hi I have a 2019 frightliner cascadia with 390.000 miles dd15 engine the truck started jerking around 320.000 miles going down the road for 1/2 sec then goes back to normal. I initially had a problem with the camshaft position sensor. Got that changed from the dealer . Ran fine for 3 months then same problem . Changed the camshaft position sensor 3 times but it still jerks sometimes for couple of seconds now. Took it to dealer multiple times they can't find an problem . Since there are no codes. I have a little oil leak from steering fluid reservoir. And while driving with wind it spreads around sometimes where one of the wire plug is you think my engine harness is bad due to oil leak please advise Thank you!
(No code)Does the ABS or stability control light flash when it jerks?
@@truckingandfixing
No lights when it jerks but ossasanly the truck does show. Performing engine shutting then I usually press override eng shutdown or take the rpm's higher. And it gives me the green check engine light and after driving for 300to 400 miles the sign goes away happend to me 3 times in last 3 months. One time it happened I took it to local mechanic . He said it showed a code for bad camshaft sensor. But how did the camshaft sensor started working again . He said your harness might be bad but after 2 days he said that he could not find anything wrong with the harness and changed the camshaft sensor. I doubt the he went thru every harness connecter and checked for correct voltage. But frightliner cannot find anything after doing dyno and taking it for test drive for 3 days
It is a complicated issue to explain here. Please call my business phone on Monday after 9am est . 330-573-5396
@@truckingandfixing will do Thank you so much!
How are you, I have a question: are you continue working with Landstar ?? I going to orientation but I have many questions before starting
Yes, I am still with Landstar. I would advice to join our Facebook Landstar owner operator group. There are many active Landstar BCOs and they share their experience and knowledge with each other, read the video description to see the direct link to join! Good luck.
Did you get significant gain in torque and horsepower back when you replaced the turbo?
How much horsepower does you truck have and what is the gear ratio in the rear in? Looking to buy a truck and need to know your numbers. I’m from Ohio also.
Sorry for the long delay. base engine is 485st, with pdi, I am supposed to be at 550. 3.42 gear ratio.
I have the same setup. I consider it to be a big Piece of Junk. Run for a week, go to the shop for a week.
If my truck is ELD exempt can I drive for Landstar?
You will be forced to run ELD
@@supertrucker1356 even if my truck is 99?
Why dont you contact them to find out
Playbox or Xstation 😆 🤣 😂
I thought about bringing my Xstation with me in the truck
Bwhahaha
Where I can buy?
You should've sprayed that whole new harness down with flex seal before you put it on.
R u gonna change out ur airintake to a pdi....I did lot better on pulling and wind up to road speed
What's the part number for the harness?