Thank you both and your institution for taking the time to make these videos on GD&T. My new job has me operating a portable CMM and while I have knowledge in autocad and reading complex prints, I am rapidly learning GD&T concepts and how they apply in practice. I am really looking forward to seeing more GD&T podcast episodes in the future!
I miss the MFT program. You guys were great, I learned so much and had so much fun. I can’t believe that our time was cut short because of this stupid pandemic.
Professor, the machinist point of view who is manufacturing a part where GD&T is being applied really interest me. Unfortunately due to my lack of knowledge over milling operation (or even because I'm an portuguese speaker not an english) I didn't understand as much as I wanted about how the part setting up procedure affects the holes position tolerances. Is there any source (maybe a channel or book) discussing about the machining procedure needed to achive GD&T requirements?
Please continue to do these kind of collaborative video. Very informative
Absolutely brilliant video
Thank you both and your institution for taking the time to make these videos on GD&T. My new job has me operating a portable CMM and while I have knowledge in autocad and reading complex prints, I am rapidly learning GD&T concepts and how they apply in practice. I am really looking forward to seeing more GD&T podcast episodes in the future!
I miss the MFT program. You guys were great, I learned so much and had so much fun. I can’t believe that our time was cut short because of this stupid pandemic.
Thanks! Always good to hear from alumni. Glad you enjoyed the program.
Please activate a save option so that i can save this for future reference in a playlist
Mr. Wickham! 😎
Thank you professor
You’re very welcome! Thanks for watching & commenting.
@@RDeanOdell professor can you make video how to make basic alignment by sphere please. Thank you
it would have been better if he could have simplified his breakdowns and talked slower and if had surface plates and pins to simulate.
Great work.thank you
Thanks so much!
Professor, the machinist point of view who is manufacturing a part where GD&T is being applied really interest me. Unfortunately due to my lack of knowledge over milling operation (or even because I'm an portuguese speaker not an english) I didn't understand as much as I wanted about how the part setting up procedure affects the holes position tolerances. Is there any source (maybe a channel or book) discussing about the machining procedure needed to achive GD&T requirements?
Thank You Sir!
Thank you for watching and commenting!