Ultrasonic Inspection of Drill Pipes

[@tauceeph501]

Nice work, what transduecer you are using? I think its angle beam at 60°? What do you recommend

[@DIYPhil]

Hi. Yes you are right. I am using the 60deg probe. This is the one that works best with the thickness of the drill pipe.

[@sU71992]

amazing explanation

[@DIYPhil]

thank you very much

[@rudyrinto567]

Thanks for ur explain about inspection of Drill pipe used UT sear wave...
Please upload again with detail caibration used V1 and V2 include side drillhole and etc..
GOD Blessing u too 😇🙏..

[@DIYPhil]

Thanks. I'll try to make a video on that if have a chance.

[@rudyrinto567]

@@DIYPhil Please make video DAC caibration for UT tool joint connection drill pipe using pipe block calibration

[@masoudsayari2117]

how you find the longitudinally cracked? especially on non magnetic drill color

[@DIYPhil]

Best if you have the probe where the contact surface is same contour of the pipe diameter then we just have to scan in the direction of the circumference of the pipe. actually, even with longitudinal scanning and ordinary probes, you can detect even the longitudinal crack. We have tried that in the past and able to detect longitudinal cracked non-mag collar.

[@htetlwinaung5672]

Which standard you referenced?

[@DIYPhil]

TH Hill's DS-1 Vol. 3

[@Yas-sv9ho]

Good work Phil. What Range you have set during inspection?

[@DIYPhil]

Hi. I used 60mm range. Enough to see the signal response up to 1-1/2 skip

[@Yas-sv9ho]

@@DIYPhil thanks Phil.

[@dude-b7d]

astig yung gantong work sir,nangangarap din ako maging NDT,saan po kayo nag training sir?kung sa pinas po nasa magkano kaya?

[@DIYPhil]

Sa APEX Engineering ako nag training, sa Las Pinas. Search mo sila sa FB.

[@BayuAgasthyaSeta]

You must be re-test UT training. Oke broo👍

[@DIYPhil]

thanks for the comment. cheers