While opening a hydraulic nut, don't forget to unturn the piston Jack by more than one and quarter turn. Otherwise the jack will get stuck coz the bolt will regain its original length but you didn't left any gap between spacer and piston assembly.
Hello my friend 👋👋👋 ! Iike a lot your video for apprentices are the best like me !!! Do you have any suggestions for the second voyage of a merchant marine engineer??
My friend u said on other video that when tightening nut. You dont need to turn back 1 or 1/2 turn open the jack. But in this video the operator made a turn back open.. Im so confuse in this, because i work with alot of people others when tightening they always said also to nake turn back open..kindly explain this.. Thanks..
Hello dear friend! Normally for tightening only tight not any turns or little bit no matter maybe he makes it to be sure that hydralics will be easy to remove by hand later on.
Hey thank you soo much, love your videos. I was hoping that you could clear one doubt, if you have the time. What is the purpose of controlled air in Hydraulic tool removal unit. ( The one you said we should depressurize while releasing the Jack's pressure)
Hello sir would you please upload video for how ELONGATION MEASUREMENTS PROCEDURES OF HYDRAULIC TIGHTENED BOLTS OF COUNTERWEIGHT CRANKSHAFT OF AUX-ENGINE, THANKS BEFORE.
While opening a hydraulic nut, don't forget to unturn the piston Jack by more than one and quarter turn. Otherwise the jack will get stuck coz the bolt will regain its original length but you didn't left any gap between spacer and piston assembly.
Nice video sir. Precise and informative!! 👍👍
Good video
Thank you!
Hello my friend 👋👋👋 ! Iike a lot your video for apprentices are the best like me !!! Do you have any suggestions for the second voyage of a merchant marine engineer??
How can I help you? Second voyage get more closer to 3 rd Engineer duties and safety of the vessel.
My friend u said on other video that when tightening nut. You dont need to turn back 1 or 1/2 turn open the jack. But in this video the operator made a turn back open.. Im so confuse in this, because i work with alot of people others when tightening they always said also to nake turn back open..kindly explain this.. Thanks..
Hello dear friend!
Normally for tightening only tight not any turns or little bit no matter maybe he makes it to be sure that hydralics will be easy to remove by hand later on.
hi my friend , has a fuel pump adjustment video?
Yes i have all the videos i will upload them as soon as possible.
thnk
Hi I'm from Indonesia. I also work with the same tool, and it is quite accurate😁
Hey thank you soo much, love your videos.
I was hoping that you could clear one doubt, if you have the time.
What is the purpose of controlled air in Hydraulic tool removal unit. ( The one you said we should depressurize while releasing the Jack's pressure)
Control air is for the pump without air you cannot work the pump always adjust control air from 6 to 7 kg per square centimeter.
@@Adventure-Story thank you, we used hand operated hydraulic pump, so we didn't have control air. So I got confused. :)
Thank you
Welcome!
Dear sir I have required this type of tools can u give suggestion, from were will i purchase this type of tools.
Hello from engine maker if requested.
@@Adventure-Story hi sir
Can u send the contact details for purchase of hydraulic tools
@@SK-fg8wc Check the manual of man or find on web!
@@Adventure-Story ok sir Thank you very much for u r Suggestion.
Hai thank you so much
Shashi Thanks!
Hello sir would you please upload video for how ELONGATION MEASUREMENTS PROCEDURES OF HYDRAULIC TIGHTENED BOLTS OF COUNTERWEIGHT CRANKSHAFT OF AUX-ENGINE, THANKS BEFORE.
Thanks for advice!
r u high ????
I don't know about him, but you are surely high my friend. Haha Cheers