Programming the Bobil Vans Solaris Controller

The Bobil Vans Solaris controller is a controller which will turn on the electric element when the battery voltage hits a programmable threshold, and turns it off when it drops below a separate threshold. This video shows how to program the controller for your desired setpoints.

[@moonhand8311]

Thank you. Nice and clear. What about P3 and O4 This is confusing in the instruction I have

[@Greenpower-t9y]

I have programmed as explained and notice that the controller does not switch off when the power drops below the 12.7 it stays on? im baffled has anyone any suggestions please

[@bobilvans4205]

Sometimes try power cycling after programming to reset the logic

[@Greenpower-t9y]

@@bobilvans4205 how is that done?

[@YouTubeArbo]

Вот бы реализовать через твердотельное реле и вход 4-20Ma,

[@manoaza09]

What is P3 and P4? Do you know maybe?

[@David_11111]

YAY

[@theoteam4641]

Do you have a hot water level sensor switch to turn on a valve to open cold water into the tank when it’s low and shut off when it’s high?

[@bobilvans4205]

Hi there - do you have the Air Xchange kit? Or the hybrid? The hybrid just automatically fills as it’s a pressurised system. The Air Xchange you can put a float sensor in to fill the tank with cold water.

[@theoteam4641]

@@bobilvans4205 I don’t have either, I am building my own hot water tank with a few things from you. I just got a 2 gauge float switch which would control a solenoid valve to allow cold water feed into the hot water tank

[@doucet2006]

How did you wire it to the mppt or battery side.
I am missing this part

[@bobilvans4205]

If you need support then email us at [e-mail]