today we'll take a look at how you can easily make your own 3.5 mm Jack antenna with coax cable so you can connect to a device externally. Check us out on Facebook: / zarduino
Thanks for this. To be sure, there are three potential connection points on the 3.5 mm Jack, right? And specifically for an antenna application, I want to make the wire connection to the long piece (and not to either/both of the other two points that are 90° offset)?
I cannot see what part of the jack is soldered to the cable, can you tell it? Thanks and great video!
Get a less echo-y mic.
Thanks for the video! However, on the most part of the video your hands are covered by an ad at the bottom that I cannot close...
Work in mobile redio Antina
How did you get the table into the culvert? 😉
Thanks for this. To be sure, there are three potential connection points on the 3.5 mm Jack, right? And specifically for an antenna application, I want to make the wire connection to the long piece (and not to either/both of the other two points that are 90° offset)?
Yeah you don't use either of the connections to the tip or ring. You only use the sleeve (typically ground).
Where do you get the 3.5mm Jack and do you think this mod can be done to use a car antenna instead of the antenna you have?
Literally any 3.5mm trs connector