How do I test run each zone for just a minute or so instead of walking back and forth to the system to turn on the next zone after im done with.previous zone?
Our controller shows the sprinkler icon flashing, but no water is coming out. Our system is programmed and yet it is still not coming on as it should be. We just had our controller changed out, because we had the same issue with the old one. Why would this be happening? What might the cause be? I did the Quick Check and there is no ERR messages. I checked the pump operation, and it is on. I have read through the manual looking for potential causes....
My Hunter XC was just turned back on for spring. Turned the supply water valves and bleed system where appropriate. Water came on but will not go off except for supply valves. Help !
Please help me, I have 6 zones, when I switch to manual, if I change from zone 1 to 2, zone 1 stops and zone 2 starts, they don't all work at the same time, how could I make several work at once? Thank you
I try to manually turn on my clock but there is a "off" display. Just the house. Never seen this before. Can anyone help me remove the "off" for the manual turn on?
Thanks a lot. This helps me to check my stations.
Very helpful. Love my Hunter ICC control panel!!!!
Thank you, very helpful
Thank you exactly what I needed to know.
Finally figured it out! Thank you!
Thanks for taking 1.5 minutes to get to the point
Good stuff buddy
Thanks for the info.
How do I test run each zone for just a minute or so instead of walking back and forth to the system to turn on the next zone after im done with.previous zone?
Excellent presentation.
You neglect to show how you advance to run only program b
Our controller shows the sprinkler icon flashing, but no water is coming out. Our system is programmed and yet it is still not coming on as it should be. We just had our controller changed out, because we had the same issue with the old one. Why would this be happening? What might the cause be? I did the Quick Check and there is no ERR messages. I checked the pump operation, and it is on. I have read through the manual looking for potential causes....
I have the same issue, how did you fix this issue?
My Hunter XC was just turned back on for spring. Turned the supply water valves and bleed system where appropriate. Water came on but will not go off except for supply valves. Help !
Yeeeay I did it ALL BY MYSELF
How do you manually run Program B?
Please help me, I have 6 zones, when I switch to manual, if I change from zone 1 to 2, zone 1 stops and zone 2 starts, they don't all work at the same time, how could I make several work at once? Thank you
My manual start and hold is not working could it be i have a hunter that does not offer it?
I have the same problem as melinda, why will my water not come on?
it shows that thing flashing but NO WATER is coming out anywhere?
I try to manually turn on my clock but there is a "off" display. Just the house. Never seen this before. Can anyone help me remove the "off" for the manual turn on?
I follow the instructions to turn stations on manually but they don't. The stations come on with the schedule. What's up?
I am having the same problem where I put it on manual and the sprinklers are not coming on. Please advise.
What if they don’t come on?
How to turn off a station
Jay come set this sh1t up for me
This system sucks........ I only want to run my system on manual, why can I not do this?
I despise this Crap system only a A WOULD ENGINEER SOMETHING SO NON INTUITIVE ;;;;
Reset sprinkler system
Screen is blank
jeez, just show it, blather about it later.