ไม่สามารถเล่นวิดีโอนี้
ขออภัยในความไม่สะดวก
Husqvarna 390xp Rebuild
ฝัง
- เผยแพร่เมื่อ 23 เม.ย. 2021
- I bought a used 90cc chainsaw with the hopes of getting it running and turning it into a milling chainsaw. It had low compression and was clearly run with straight gas. I bought and installed a piston and cylinder kit as well as some new plastics. Enjoy!
Superbe dépannage réparation bravo c'est un chef ça mérite bien 2 pouces
Good to see ya again! Hope you’re doing well.
Thank you, this was easy to follow along with. Superb job on the cuts / edits puns intended lol.🤘🤠🤟
Ready for Freddy
Sounds like a beautiful machine now!
@@LukeMixter Friend, what is the best max speed for 372 xp oem?
@@LukeMixter Friend, if the saw 372 xp after replacing the OEM piston, the compression will increase? after a few tanks now it is only 140 psi after refurbishment
@@LukeMixter can i set 13200 rpm for 372xp oem after one blown tank? saw after replacing the piston ...
bucking spike is on upside down.
Ok when u put the new gasket on and put the new cylinder on u didn’t use any sealant ??
does the 390xp have crank seal on the PTO side?
Why would you put it together dry
Hola señor
If I'd a known it was ran with straight gas I would have put a new bottom end in it.
Made in Brazil?
como estas hoy señor
straight gas??? OMG poor chain saw !!
Never use those Oregon spark plugs there junk , ruend one of my saws with those plugs
Lots of rookie mistakes but you'll figure it out
amateur