Creo Parametric - Manual Cabling Process (Video 2)
ฝัง
- เผยแพร่เมื่อ 1 ต.ค. 2024
- This Creo Parametric tutorial provides an overview of the Cable Harness design process using manual cabling practices.
For more information, visit www.creowindch....
If you learned something from this video, please give it a thumbs up. If you like this video, please click the Subscribe button to be informed when new videos are uploaded. Also please write a comment if you would like to see more videos like this.
Feel free to share or embed this video, and add it to your playlists.
Creo admins, you can share the Creo Parametric channel with your users as a training tool:
tinyurl.com/Cre...
Thanks,
Dave
I didn't know that laying cables could be so simple and beautiful.
Great video that i was looking for long time, well explained, now looking for next auto routing,.. thank you..😊👍
Really I need to appreciate you for making this video, your knowledge about cabling too good.
Kindly suggest me, how to improve knowledge regarding cabling, schematic and diagram
Why can't SolidWorks do this? Routing is atrocious in SolidWorks.
How do we calculate the mass of the cable and their CG for overall mass property and CG caldculation? Both CG position and mass are critical to us.
I think I touch on this in my video on Cable Spools. If you specify the spool's linear density (note that linear density is the mass or weight per unit length, not unit volume like regular density), you should be able to calculate mass properties as usual. It's been a few years since I've done cabling and made this video, so I recommend testing this to be sure and reaching out to PTC Tech Support as necessary.
Do you have explained somewhere in your videos how to use correctly the concept of sub connectors ? Or maybe you can guide me to a document explaining this in detail ? It look I managed to make it work visually but impossible to extract the logical connection in the repeat table correctly.
I investigated subconnectors once for a work issue. The functionality seemed wonky. I have not revisited it since.
Can you please share any knowledge on how to make form board in creo cabling harness
Best teacher! Thank you! 👍
Thank you sir,, very clear . Great video..
Thanks for watching!
When routing a network manually do I need to route to each individual connector or is having the network close by sufficient?
Also thank you so much for your video series!!!
You do NOT want to route the network into each individual connector. That causes problems with generating short segments that cause little loops or minimum bend radius issues. You just want to have Network Locations where wires and cables and jump into and out of the network.
@@CADPLMGuy ok that would explain my min bend radius issues I have been having.
My networks always start on the "floor" or panel surface. Later if I want to make the wires pretty and go straighter into the connector, I add a Location to the cable (not the network), usually on an axis coming out of the connector.
@@CADPLMGuy thank you so much!!!
Thank you for the video.
Thanks for watching!
excessive TALKING!!!!
If the FREE content that I have created on my own time isn't good enough for you, I'm not forcing you to watch my videos. Perhaps another channel will be more to your liking. Alternatively, you can pay thousands of dollars for formal training from PTC or other training vendors.