So what were you actually doing in this video? Is this a repair of the flex on an original battery, or are you putting in a replacement battery and repairing the unknown part message? At the end you turn on, it says unknown part, then you turn off, then turn on again and the unknown part message is gone. Did you do anything else between turning off and back on, or is turning it on twice enough to remove the message?
Hello I have been using the tag-on flex from JCID since 5 months ago and I think they are pretty convenient, but there is a problem with the models 11 Pro and 11 Pro Max, when I do the steps to put the new battery with the old flex id to read 100% into the mobile phone everything is fine but after almost 1 week using it, the phone instantly turns off and since then the phone always shows 1% percentage, identify the battery as non original and turns off every 5 minutes. Note: When I do the procedure to read the 100% maximum capacity I take out the tag-on flex, I mean... Is the tag-on flex designed to let it installed on the phone?
I have bought 3 jcid tags in flex for iphone 11, but none of them succeeded in changing the battery health to 100%. Even though you have followed the tutorial as in the video it still doesn't work, after restarting the iPhone with the jcid tag on the flex still stuck to the battery the battery always shows 1% and when connected to the charger it says 0% the rest, please help if anyone experiences a similar case please give me the solution
I have the same problem :( in my case it shows me the old percentage and not 100%, I am supposed to buy one of these flexes to avoid buying a programmer and I think I have to resort to that
does it work when i dont use the old flex battery ?
So what were you actually doing in this video? Is this a repair of the flex on an original battery, or are you putting in a replacement battery and repairing the unknown part message?
At the end you turn on, it says unknown part, then you turn off, then turn on again and the unknown part message is gone. Did you do anything else between turning off and back on, or is turning it on twice enough to remove the message?
Does it work with v1s or only the newer v1se?
Hello I have been using the tag-on flex from JCID since 5 months ago and I think they are pretty convenient, but there is a problem with the models 11 Pro and 11 Pro Max, when I do the steps to put the new battery with the old flex id to read 100% into the mobile phone everything is fine but after almost 1 week using it, the phone instantly turns off and since then the phone always shows 1% percentage, identify the battery as non original and turns off every 5 minutes.
Note: When I do the procedure to read the 100% maximum capacity I take out the tag-on flex, I mean... Is the tag-on flex designed to let it installed on the phone?
I'm facing the same problem, including with the common iphone 11. Could anyone tell me where I'm going wrong?
I have the error on v1se of no repair flex cable..
tengo una VS1, y los flex V3.0, pero no los puedo editar
I have bought 3 jcid tags in flex for iphone 11, but none of them succeeded in changing the battery health to 100%. Even though you have followed the tutorial as in the video it still doesn't work, after restarting the iPhone with the jcid tag on the flex still stuck to the battery the battery always shows 1% and when connected to the charger it says 0% the rest, please help if anyone experiences a similar case please give me the solution
I have the same problem :( in my case it shows me the old percentage and not 100%, I am supposed to buy one of these flexes to avoid buying a programmer and I think I have to resort to that
Sorry to hear that, please contact JCID technical support for technical problem, thanks.
I have I2C program tool can program this external ?
No, i2C can operate only with i2C cables, same with other programmers