Yeah, after doing what I show in this video, tying it to the Door open Mcode and output signal is straightforward. On our Doosans all of that stuff is already programmed in the PMC for the Autodoor. All you have to do is manipulate the ladder to do what you'd like it too. This is so much easier than Haas or Mazak. I have to program another mill next week. Let me see if I have time to make another video from start to finish.
@@ericwhittaker3570 that would be great. I run a bunch of doosan millturns and want to add an autodoor for another robot. Were you able to find any good documentation that walks through some of these procedures from doosan or Fanuc?
Are there no manuals on your cabinet? Usually, that's where they are. Each electrical manual seems to be tailored to the model family to which it belongs.
@@ericwhittaker3570 I have the manuals, just looking for more instruction on the editing and wiring of adding external hardware into the pmc of the control.
![[안방1열 직캠4K] 베이비몬스터 치키타 'FOREVER' (BABYMONSTER CHIQUITA FanCam) @SBS Inkigayo 2404707](http://i.ytimg.com/vi/Tn3bGHiBWkg/mqdefault.jpg)
Any chance you would know how to tie an M Code to that switch or bit to open the doors at the end of the cycle?
Yeah, after doing what I show in this video, tying it to the Door open Mcode and output signal is straightforward. On our Doosans all of that stuff is already programmed in the PMC for the Autodoor. All you have to do is manipulate the ladder to do what you'd like it too. This is so much easier than Haas or Mazak. I have to program another mill next week. Let me see if I have time to make another video from start to finish.
@@ericwhittaker3570 that would be great. I run a bunch of doosan millturns and want to add an autodoor for another robot. Were you able to find any good documentation that walks through some of these procedures from doosan or Fanuc?
Are there no manuals on your cabinet? Usually, that's where they are. Each electrical manual seems to be tailored to the model family to which it belongs.
@@ericwhittaker3570 I have the manuals, just looking for more instruction on the editing and wiring of adding external hardware into the pmc of the control.
Ah. Hopefully I have time next week to film the next mill wiring. Hang tight.