Just installed the kit in my a91mt. I know it flashed correctly because I can do what you’re doing. But when I try to read ethanol it says zero. I had two bars of 93 then filled 4 gallons of e85 and now I have 4 bars of gas and drive several miles and it still reading zero. Thoughts?
I replied on the forums but I'll do it here too. Most pump gas has 10% Ethanol so you should have been reading some from the start. Sounds like a wiring issue. I would triple check the install and then contact BM3 if it still doesn't work. I'm assuming you are also seeing 0 in the app?
The hero of SupraMKVforums.
Which ethanol sensor are you using? I am using MHD. Also , can changing maps happen while driving or need to be stationary?
What about antilag. I thought you hold it down as well. Or is it up for antilag?? How does it differentiate between antilag or map switching.
Can you only switch maps in diagnostic mode or can you do it on the fly with the car running?
With car running as well
Just installed the kit in my a91mt. I know it flashed correctly because I can do what you’re doing. But when I try to read ethanol it says zero. I had two bars of 93 then filled 4 gallons of e85 and now I have 4 bars of gas and drive several miles and it still reading zero. Thoughts?
I replied on the forums but I'll do it here too. Most pump gas has 10% Ethanol so you should have been reading some from the start. Sounds like a wiring issue. I would triple check the install and then contact BM3 if it still doesn't work. I'm assuming you are also seeing 0 in the app?
How did u wire it ? Car is runung fuel -it kit is remove the bluetooth kit and wirie it directly but still show 0 on cluster .. what i miss ?
You need to have the CANbus compatible version