Those parameters of Thread Coarse Pitch are very different from what was shown in the other video. The Thread Coarse Pitch looks smaller than the video you refer to. Greetings!
At minute 2:23 the "Lookup Table Name" does not correspond to the "Pitch" formula, for a value of Nominal Diameter (ND) = 12mm , the values of: Pitch (P) = 1.75mm (But in Revit it is 2.2mm) Minor Diameter (MDM) = 9.853mm (This is OK). Could you please share the correct CSV table?, since when applying the formula "No of Thread = (Length/Pitch) -2" it generates too many copies
I meant could you share your csv with which you obtained a value of "Pitch = 2.2 mm" for "Nominal Diameter = 12 mm" at minute 2:23 or share your family "Thread Rod.rfa", since it gives me problems and I can't create that Revit family
Those parameters of Thread Coarse Pitch are very different from what was shown in the other video. The Thread Coarse Pitch looks smaller than the video you refer to.
Greetings!
You may need to adjust up the pitch value for M10-M14 in CSV file. Because the line shorter than 0.8mm will get error.
@@ThomRVT Thanks!!!!
Can senf your csv file
At minute 2:23 the "Lookup Table Name" does not correspond to the "Pitch" formula, for a value of
Nominal Diameter (ND) = 12mm , the values of:
Pitch (P) = 1.75mm (But in Revit it is 2.2mm)
Minor Diameter (MDM) = 9.853mm (This is OK).
Could you please share the correct CSV table?, since when applying the formula "No of Thread = (Length/Pitch) -2" it generates too many copies
Please can your csv via email? I can take a look.
I meant could you share your csv with which you obtained a value of "Pitch = 2.2 mm" for "Nominal Diameter = 12 mm" at minute 2:23 or share your family "Thread Rod.rfa", since it gives me problems and I can't create that Revit family
@@ThomRVTok, what's your mail?
Could you show us what was done. Because it looks smaller than the video that explains how to make the piece.
Thank you!