Hello, will this DPS work in suction? I want a signal to be generated when the pressure is reached below the set point and not above. Is this possible with this switch?
@HarshilParmar Thank you for your question. I think when we set the Pa maximum range in Differential Pressure switch, if its reach above the setpoint NO is activated , after it comes setpoint range NC will activated. in this case the Pa goes below the setpoint range no changes accrued the NC always in active.
1 st Terminal is Phase, 2nd Terminal is switch position 1-2 is lower pressure, 3rd Terminal is switch position 1-3 is Higher pressure, you take wire from Terminal 2 and connect to any Lamp,buzzer are Alarm devices..
Can i direct the line between NO and common or no
Tnx for suggesting me...... By the way made video on PID VALVE OVENTROP ..
Ok Sure...
Thanks for your Support...
Hello, will this DPS work in suction? I want a signal to be generated when the pressure is reached below the set point and not above. Is this possible with this switch?
@HarshilParmar
Thank you for your question.
I think when we set the Pa maximum range in Differential Pressure switch, if its reach above the setpoint NO is activated , after it comes setpoint range NC will activated. in this case the Pa goes below the setpoint range no changes accrued the NC always in active.
www.beck-sensors.com/en/differential-pressure-switch-930-adjustable/
How can I connect a alaram if pressure is low
1 st Terminal is Phase,
2nd Terminal is switch position 1-2 is lower pressure,
3rd Terminal is switch position 1-3 is Higher pressure,
you take wire from Terminal 2 and connect to any Lamp,buzzer are Alarm devices..
Can I get your phone no please
@@rashmiranjanmahapatra8769 what kind of problem you facing
www.beck-sensors.com/en/differential-pressure-switch-930-adjustable/