Hello, will this DPS work in suction? I want a signal to be generated when the pressure is reached below the set point and not above. Is this possible with this switch?
@HarshilParmar Thank you for your question. I think when we set the Pa maximum range in Differential Pressure switch, if its reach above the setpoint NO is activated , after it comes setpoint range NC will activated. in this case the Pa goes below the setpoint range no changes accrued the NC always in active.
1 st Terminal is Phase, 2nd Terminal is switch position 1-2 is lower pressure, 3rd Terminal is switch position 1-3 is Higher pressure, you take wire from Terminal 2 and connect to any Lamp,buzzer are Alarm devices..
Tnx for suggesting me...... By the way made video on PID VALVE OVENTROP ..
Ok Sure...
Thanks for your Support...
Can i direct the line between NO and common or no
Hello, will this DPS work in suction? I want a signal to be generated when the pressure is reached below the set point and not above. Is this possible with this switch?
@HarshilParmar
Thank you for your question.
I think when we set the Pa maximum range in Differential Pressure switch, if its reach above the setpoint NO is activated , after it comes setpoint range NC will activated. in this case the Pa goes below the setpoint range no changes accrued the NC always in active.
www.beck-sensors.com/en/differential-pressure-switch-930-adjustable/
How can I connect a alaram if pressure is low
1 st Terminal is Phase,
2nd Terminal is switch position 1-2 is lower pressure,
3rd Terminal is switch position 1-3 is Higher pressure,
you take wire from Terminal 2 and connect to any Lamp,buzzer are Alarm devices..
Can I get your phone no please
@@rashmiranjanmahapatra8769 what kind of problem you facing
www.beck-sensors.com/en/differential-pressure-switch-930-adjustable/