Cara Reset Factory Default Printer Intermec (Honeywell) PD41
ฝัง
- เผยแพร่เมื่อ 9 ก.พ. 2025
- Jangan lupa subscribe dan like. Bagi yang subscribe saya doakan ilmunya bermanfaat dan rejekinya lancar. Amin.
Don't forget to subscribe and like. For those who subscribe, I wish for their knowledge to be useful and the fortune always with you. Amin.
Cara Reset Factory Default PD41
1. Matikan printer.
2. Buka printhead ke posisi atas.
3. Tekan dan tahan tombol feed biru, hidupkan printer dan tunggu tiga LED terbawah menyala kelap-kelip pada saat yang sama dan lepaskan tombol feed.
4. Turunkan printhead dan LED biru bawah akan mulai berkedip.
5. Tekan dan tahan tombol feed sampai 2 dari hijau atas LED berkedip, lalu cepat-cepat lepaskan tombol feed
6. Buka printhead ke posisi atas, tekan dan lepaskan tombol feed sekali. Tiga LED terbawah akan mulai berkedip.
7. Tutup printhead ke posisi bawah, tekan dan lepaskan tombol feed sekali. Tiga LED terbawah akan mulai menyala bergantian.
8. Printer akan melakukan warm boot dalam 20 sampai 30 detik.
Set Factory Default PD41
1. Turn the printer off.
2. Raise the printhead to the up position.
3. Press and hold the blue feed button, turn the printer on and wait for bottom three LED's to flash at the same time and release the feed button.
4. Lower the printhead and the bottom blue LED will start flashing.
5. Press and hold the feed button until the 2nd from the top green LED flashes, then quickly release the feed button
6. Raise the printhead to the up position, press and release the feed button one time. The bottom three LED's will start flashing.
7. Lower the printhead to the down position, press and release the feed button one time. The bottom three LED's will start scrolling.
8. The printer will warm boot in 20 to 30 seconds.
