Wow thank you for your video. It just saved my life! I just finished at 200am in the morning. The small motor two screws came off and I didn’t know how to open it. I didn’t know nothing until I saw your video and I saw how to put everything back together. Thank you.. 🫡👑💪🏼🤙🏼💯💯💯💯💯💯
Nice video, I had to take a green stripe apart and clean out the optical sensors, it was giving me an opto-blocked notice about once a week. Once I had it apart, it wasn't as dirty as I thought it would be.
when i was removing the side with the sensor board the heads (6)snapped off! I never had that happen while taking screws off. Any suggestion on how to get the broken studs out of the plastic. Tried easy out and small drive bit but i think the screws are stainless so i have not been able to drill them out
hmm, I think this happens because they have been over tightened. Dou you now need the center section of the hopper or the black outer case? lasvegascoinop@gmail.com
I have a green stripe that is not dispensing and showing no error codes? Is it possible the motor has failed? The bill is accepted and there is no sound or anything. It will keep the bill but reject the next one.
Yes, likely something in the hopper. Does the control board in the change machine operate on 24 volts with a green screen or is it the older 115 volt model with the 5 red digits up top? lasvegascoinop@gmail.com
Wow thank you for your video. It just saved my life! I just finished at 200am in the morning. The small motor two screws came off and I didn’t know how to open it. I didn’t know nothing until I saw your video and I saw how to put everything back together. Thank you.. 🫡👑💪🏼🤙🏼💯💯💯💯💯💯
Thanks for watching and hopefully subscribing!
Nice video, I had to take a green stripe apart and clean out the optical sensors, it was giving me an opto-blocked notice about once a week. Once I had it apart, it wasn't as dirty as I thought it would be.
tanks very much very clear and good way to expelan every thing
Thanks for the support Jaime!
when i was removing the side with the sensor board the heads (6)snapped off! I never had that happen while taking screws off. Any suggestion on how to get the broken studs out of the plastic. Tried easy out and small drive bit but i think the screws are stainless so i have not been able to drill them out
hmm, I think this happens because they have been over tightened. Dou you now need the center section of the hopper or the black outer case? lasvegascoinop@gmail.com
I have a green stripe that is not dispensing and showing no error codes? Is it possible the motor has failed? The bill is accepted and there is no sound or anything. It will keep the bill but reject the next one.
Yes, likely something in the hopper. Does the control board in the change machine operate on 24 volts with a green screen or is it the older 115 volt model with the 5 red digits up top? lasvegascoinop@gmail.com
@@dougsworldtour3755 Thanks for the quick reply. It has the green screen.
Where do we get parts like gear set?
dougbaleenterprises.com/shop/ols/products/eject-finger-for-money-controls-hopper-0-slash-25-cent
dougbaleenterprises.com/shop/ols/products/american-changer-green-stripe-hopper-lowest-large-gear-new
Problem erreur hopper
lasvegascoinop@gmail.com for help