Camera Sensor Reball

[@bojcio]

impressive work

[@anisnajar4424]

Please what microscope do you use for your work?

[@tecforlyf]

i think i had to use the hot gun from downside of the board!

[@supercomputing942]

yes is always safer that way

[@tecforlyf]

after reballing it went blurr little bit

[@MrQuazar]

Because bga balls was not same size, its need to be optical correction

[@electronics-by-practice]

U can try to adjust the focus by rotating the lens if it was a simple CCD camera.

[@vloggerazeem86]

How much heat and air you kept on that sensor coz this thing gets damages because of too littlest heat

[@supercomputing942]

sensor its very risky to change it but 350c. 60% air speed. Be quick. Leaded solder make faster bond. Also heat from bottom is safer.

[@t76480]

what was the heating temperature?

[@MrQuazar]

Lets try apple A10 handmake😂

[@Garadasa]

what's that liquid its in, you will have to taker it off the sensor after, how ?

[@supercomputing942]

which liquid. Its no-clean-liquid flux and then clean with alcohol. Alcohol will dry itself.

[@serjio193]

Repaired?
Yes.
Works?
No.
:)

[@RubyWasntTaken]

wdym?

[@snik2pl]

What was this camera?

[@supercomputing942]

cctv

[@j.lietka9406]

What kind of chip is that?

[@TanajiChang]

It's the sensor of the camera

[@j.lietka9406]

@@TanajiChang hmm... thank you

[@TanajiChang]

@@j.lietka9406 Most welcome.