Fixed support is given to the stud holes because wheel is fixed by the bolt through stud holes in vehicle axle. The bearing load is applied on the rim.
Fluctuating loads or repeated cyclic loads comes under fatigue They fail much much below there ultimate/yield point because of cyclic stress Ex: once in a point of time,you would have cut a thread with your hands (may be when flying kite or tying things) You might have observed thus: shaking thread vigorously (pulling and contracting ) to detach the thread easily This is nothing but fatigue ,you are applying cyclic load!
Very helpful video
Hi sir I am research scholar and I need your help in my research work
why do you give remote force and pressure in half of wheel
Can you explain , Why does determine the pressure occur on one side? Pls
why did you set the pressure value to this?
Hello, how did you determine the amount of force and pressure applied to th rim?
Why the fixed support at the stud holes? can you please explain
Fixed support is given to the stud holes because wheel is fixed by the bolt through stud holes in vehicle axle. The bearing load is applied on the rim.
@@ashokreddy2873 Thank you :)
What Wheel of the carriage
What is wheel of the car
Can you explain what exactly fatigue analysis means?
Fluctuating loads or repeated cyclic loads comes under fatigue
They fail much much below there ultimate/yield point because of cyclic stress
Ex: once in a point of time,you would have cut a thread with your hands (may be when flying kite or tying things)
You might have observed thus: shaking thread vigorously (pulling and contracting ) to detach the thread easily
This is nothing but fatigue ,you are applying cyclic load!
@@soujanyakonjeti8982 ok thanks for u r reply.
Can you share file? please
Can you please send me the igs file
Can you share iges file please
Send me your email ID.
@VIVEK please forward me the igs file if you have !
@@ashokreddy2873 can u please send me the igs file urgently ??
Hello Sir,can you please share Iges file
Give me your email id.
@@ashokreddy2873 17h61a03a7@cvsr.ac.in
@@ashokreddy2873 can you please share the iges file with me as well?
@@ashokreddy2873 AnasAyed1998@outlook.com
@@ashokreddy2873 i received your email but when i import it it says the model is made of 493 parts and my laptop is taking to much time to mesh it
Can u help me broo??
helo, safety factor why greater than zero? so it is not safe ? isn't ?
yes, but it depends on the material selected, type of load applied, working condition, material properties.