Hi Gohar, great video! I'm using the same Klic-DD v3, but with MDT Glastaster II button. I can get this integration to work with ON/OFF. But temperature control is only possible when I send a fixed temp. value (2byte), say 20°C. But I'd like to increase/decrease the temp. with the buttons. This doesn't work unfortunately... Do i really need a room temp. controller or heating actuator for this to work?
Did you try to use temperature shift with "2byte shift of basis comfort setpoint value" and to put there the step width as 1 ? I see the parameter is the same type.
@@denisaspenleiter4330 I still haven't finished the integration yet as I was busy doing other integrations in my house. But thanks for the reminder, I'll try the suggestion from cipid2001 above. If this doesn't work, I guess a room temp. controller is needed.
Its really easy to understand your method of teaching. Thank you sir
You are welcome, thanks for your feedback.
Nice attempt keep going
Thanks buddy - exactly what I needed for my new Daikin AC with KNX :-)
thank you Gohar
I use Jung push bottom compact for control AC
It was so useful.
You are welcome brother.
thank you man, great video.
Can you show us the connection between KLIC-DD v3 and air condition?
Pro tip : you can watch movies at InstaFlixxer. Me and my gf have been using them for watching loads of movies lately.
@London Noel yup, I have been using InstaFlixxer for since november myself :D
@London Noel Yea, been using InstaFlixxer for since december myself :)
how to connect the AC physically to the KLIC ?
Hi Gohar, great video! I'm using the same Klic-DD v3, but with MDT Glastaster II button. I can get this integration to work with ON/OFF. But temperature control is only possible when I send a fixed temp. value (2byte), say 20°C. But I'd like to increase/decrease the temp. with the buttons. This doesn't work unfortunately... Do i really need a room temp. controller or heating actuator for this to work?
I think you need a room thermostat. Will need to setup it as slave device.
Did you try to use temperature shift with "2byte shift of basis comfort setpoint value" and to put there the step width as 1 ? I see the parameter is the same type.
Hello Mark. I have the same problem as you. Did you get a solution for it? I am struggling right now
@@denisaspenleiter4330 I still haven't finished the integration yet as I was busy doing other integrations in my house. But thanks for the reminder, I'll try the suggestion from cipid2001 above. If this doesn't work, I guess a room temp. controller is needed.
Sir, I would like to get support from you during the commissioning time.
No problem, send me an email, and we will discuss.