I understand but I want from the automatic change over remote start to the generator when the ecg goes of how do thE change over send the signal to the GEN to start
@@electreca1 good evening, thanks for the upload, very informative. I was hoping to see a demonstration from the terminal block of the generator to the changeover switch
Hello mister David Just a dude from south Africa who's injoying your channel,can you talk about pump protective Relay (PPR3T8)and distance control unit (DCU) please
Thanks for the video....So for remote start of the diesel generator in an ATS circuit, if i am using this sane cintrol panel, i would connect terminal 5 to the Normally close contact of mains relay or contactor to the terminal 24. So if the mains fail, Terminals 5 and 24 would be connected, hence the generator starts. Is this correct?
Weldone bro, am inspired by your work. Please how do I run a remote start and stop for my firman sumec 3.0kva generator provided I have an automatic changeover switch?
In most cases the company that supply the controller also makes the control panel. So yes the terminal numbers and control design changes as per controller company.
If you can start this generator by using this 2 connector to a remote switch.... 😮then how does the generator stop ?...by switching the remote switch off?...
God bless you sir
Also sir please can you share control circuit for ATS of motorized circuit
Important source of information my brother
I understand but I want from the automatic change over remote start to the generator when the ecg goes of how do thE change over send the signal to the GEN to start
Don't worry, the video 'll be up soon.
Thanks for watching
Okay 🙏
@@electreca1 good evening, thanks for the upload, very informative.
I was hoping to see a demonstration from the terminal block of the generator to the changeover switch
Good job brotha!
Hello mister David
Just a dude from south Africa who's injoying your channel,can you talk about pump protective Relay (PPR3T8)and distance control unit (DCU) please
Please I need the link for the manual
Thanks for the video....So for remote start of the diesel generator in an ATS circuit, if i am using this sane cintrol panel, i would connect terminal 5 to the Normally close contact of mains relay or contactor to the terminal 24.
So if the mains fail, Terminals 5 and 24 would be connected, hence the generator starts.
Is this correct?
Yes, correct
Please give me manual for this
Thank you for the explanation. Please can you explain difference between single phase and 3 phase ATS? From PNG.
I will do that, thanks for watching.
you were born to do this .superb
Weldone bro, am inspired by your work. Please how do I run a remote start and stop for my firman sumec 3.0kva generator provided I have an automatic changeover switch?
Are you to be shown were remote start cable is connected on you DG?
@@electreca1 yes,
Does those terminals numbers changes depending on each controller or they are constant
In most cases the company that supply the controller also makes the control panel. So yes the terminal numbers and control design changes as per controller company.
keep it up am learning
❤❤❤
Link for manual please
That’s great
Super
If you can start this generator by using this 2 connector to a remote switch.... 😮then how does the generator stop ?...by switching the remote switch off?...
But the video is not clear
AFRICA,
BE INDEPENDENT! KEEP AMERICA AND EUROPE OUT OF AFRICA!
please let have ur contact