How to Make LED CHASER using Arduino UNO-32 Patterns

In this video you can find 32 pattern of Led chaser using Arduino UNO.
Components used in this Projects are:
1. Arduino Uno
2. LED's
3.Bread board
4.Jumper wires
5.Data cable
Code & Circuit diagram
1drv.ms/f/s!AuH5vkyZSRZQiyT1l...

[@user-pm8sx1xl6j]

Nice👌👌👌

[@cxm7231]

GOOD JOB 👍👍👍👍

[@selvarajp273]

Nice

[@user-vd9jv6xf3t]

super

[@narayankatore526]

can we operate this with switch on or off

[@discovery1986]

nice job, i get the code, but only 15 patterns? greets

[@Shalakushka]

Hi, I'm still a beginner and I was wondering why you don't need a resistor for the leds ? Anyway, nice video and thanks for sharing the project.

[@360viewplus]

Ya I didn't use resistor for led here because this led can glow (withstand) upto 5v.From Arduino UNO the output is 5V.I hope you have understand.

[@360viewplus]

Thanks for sharing 🙏

[@Shalakushka]

@@360viewplus I did understand. Thanks !

[@discovery1986]

even when its posible, i sugest to allways use a resistor! one of 100oHm will do it. than you have just a litle bit of protection. @@Shalakushka

[@360viewplus]

@discovery1986
I agree dude

[@MrSomesouls]

Thanks for your kind. can we use mini arduino?

[@360viewplus]

Yes sir,You can use Arduino nano also

[@MrSomesouls]

@@360viewplus how about the pins? can we set the same numbers with Uno?

[@MrSomesouls]

I have tried using UNO, it's OK, good Job. but when I tried it using nano, it does not work. why??

[@360viewplus]

Yes

[@360viewplus]

Check while uploading wheather the nano is selected correctly in Arduino IDE

[@abincm984]

Can you send me that code