How to install a Faller car system guide wire

In this video i show my take of installing the guide wire for the Faller car system. Just a little test track out of an old drawer cabinet and also a place to store my spare parts for future projects.
Credits:
intro music supplied by bensound.com
Starter set supplied by www.trainz.co.za/

[@HOTRAINUNIVERSEANDDIORAMAS]

Very good description. Short and easy to understand. But I'll recommend super glue with soda.... That's good.

[@paulsharpe3794]

Hi there I'm just about to start working on a layout and I'm planning on fitting a faller road. I'm going to use an ARDUINO with 9g servos for the points. And so I'm looking forward to seeing how you are going to operate your vehicle's with ARDUINO. So I've subscribed good luck

[@scaletraintechandthings8945]

Thank you,

[@skelligringphotographyandw7012]

I didn't catch the type of cutting bit you are using. Can you tell me again please!

[@scaletraintechandthings8945]

Hi it is called a router bit.

[@gemini9424]

Dankie. Dis n great video maar wat maak dat die trokkie die kabel volg. Is dit n magnetise kabel of is die metaal onder die trokkie magneties. Die volgende vraag is natuurlik hoe lank loop die trokkie op n gelaaide batery?

[@scaletraintechandthings8945]

Daar is n magneet op n brass stuurstang wat die draad volg.

[@trainsmarocains]

The working voltage of the vehicle engine please

[@MrLosttheplot]

great video, thank you

[@scaletraintechandthings8945]

You are welcome!