How to adjust the front end sweep cams on a AMF 8270/8290xl

[@no1froggy]

You can also get sweep drifting if you have MP chassis (or the older 5/6 card chassis) if the sweep contactor is defective or C1 or C2a pins are bad.

[@elikenyon2642]

How do you know when you have to adjust the cams?

[@michaelleybon2100]

What if the sweep is stopping to late during a cycle and hits the head pin? What would be the proper adjustment?

[@CliffWalrus]

In case you haven't fixed it yet:
check your respot cell to make sure the pin isn't sitting too low, and then you can turn out TA2 a lil bit. If your sweep is coasting back though you might have to compensate by adjusting your SB. Ideally you would fix the coasting issue which could be a whole other can of worms.

[@young72081]

Michael Leybon

[@robertjackson8963]

I’m getting a lot of hanging bananas, after the sweep clears the deck of knocked down pins, when try he sweep comes back it will stop before it comes back into the gaurd position causing the machine to lockup. Would this be a cam adjustment issue?

[@joehutchinson3099]

I have the sweep stoping behind the pins what do I adjust

[@therealkayoh2888]

So how would I switch a motor from being odd or even for the table motor I am having issues on an odd machine rebuilding a motor

[@reubenperry485]

when 1 of my sweeps comes down its higher on the right hand side and its blocking the camera and giving wrong scores , can you please help me with this problem

[@RajeshKumar-xw3eo]

Pin Malfunction detected problem what is solution.

[@marlonsolejon4818]

The sweeper of my machines is continuesly running? Any ideas whats the problem?

[@ddddddddddddddddddddd-o4o]

nice bro

[@emmanouildrosopoulos7894]

hey my frien dit you still work as bowling technician ?

[@jimcrawford5603]

It's safer just to use the go no-go gauge .