Need to liquid nail the seat down and and a cheap cover 😊
Little torch up paint and repaint the dash really helps the looks and paint the deck is a winner 😊
Danger Will Robinson! Lol
At my shop I call that last mower blade a toothpick. Love your videos.Going try to take a few days off and rest.Happy Fourth of July to you and everyone!
190cc Quantum’s are scary. Be careful Tommy!
I wonder if red green owned that "duct tape special "?! That was probably one of the worst I've ever seen lol! I got my stickers tommy thank you so much I love em' !
Holely decks. I have never seen such rusted out decks before .
Wow, those are some real rust buckets!! I was shocked that Quantum fired up and ran on it's own!! I'm going to tinker on a Quantum today that starts first pull when cold and runs fine but will not start again once it's hot. Same mower I did the body work on.
Quantum fixed!! Put a wire brush in my drill, pulled and cleaned the ignition coil and gapped it correctly. Starts first pull, hot or cold!!
Weigh kool them ole battle axes starting and running. Florida is rough on your power equipment w/heat and sand. Everything gets rusted, weathered or loosen up😁
Holy Rot!!! All the years I’ve been doing this. I don’t remember seeing one that bad. Engine sounded great though
Bernie, really rough condition. I do not know how they could cut grass towards the end of its Life.
Those quantums work on toro if you drill and tap crankshaft to 7/16 nf
It’s 235 am and fixing to close shop and get some rest, tomorrow is going to be 107 by noon 😢😢😢
You know with a little work, you could do an excellent Jack Nicholson impression. Might add a little something to the channel, might make it blow up. I think you have the personality to pull it off.👍
I’ve been thinking about the other Toro that needed the blade hub. Maybe check the flywheel key too. That may be why it was kicking back?
thank you, that is in the back of my mind. new adapter came in for it.
I have basically the same cutting deck as that yard machines mower, on a cheap Murray that I have been using the past few years. It is without a doubt the worst cutting thing I've ever seen, especially without the anti-scalp accessory wheels. Terrible decks, not enough adjustability.
Whoever owned the two craftsman mowers shouldn't be allowed to own or operate machinery of any type.
Dam it’s bad, pull engine and put on test stand, keep wheels and rest is rust 😢😢😢
I love seeing these extreme rusted out mowers show up on your channel and some others...amazing how far people will use something before finally throwing in the towel.
Thank you for looking at this rusted JUNK.!!