ขนาดวิดีโอ: 1280 X 720853 X 480640 X 360
แสดงแผงควบคุมโปรแกรมเล่น
เล่นอัตโนมัติ
เล่นใหม่
That's cool😎! Thanks Ninja
You´re welcome friend. Best Regards
Thank you very much!
Thanks so much for sharing your knowledge.
You're welcome friendBest regards
thank you so much
You're welcome friend.Best regards
very nice! can you make a refrigerator analysis video?
Thanks, I will try friend.Best regards
مرسی
thank you four your sharing, ı have a question how can ı calculate here bend factor(Kl) to find pressure loss, ı am try solving with hand too.
Kindly request sir please make one vedieo for nonlinear analysis vedieo and bucking
Hello sir. Thank you for this video. I had 1 doubt. How is the air flowing through the pipe when the pipe is not made hollow in the geometry?
Hi friend;In this case the fluid is water and there are three hollow (2 inles and 1 outlet).
is there any simulation tutorial where two different liquids injected into two different inlets? foe example, water injected into inlet1 and blood injected into inlet2. is it possible?
th-cam.com/video/HDMY3LOEez0/w-d-xo.html
@@ansys_cfd Thank you so much!!
I am trying to change element size but it is again set to default element size.
Hi! if i need to the solid rotate, which parameter i must change?
There is a option to rotate in the Task bar
That's cool😎! Thanks Ninja
You´re welcome friend.
Best Regards
Thank you very much!
Thanks so much for sharing your knowledge.
You're welcome friend
Best regards
thank you so much
You're welcome friend.
Best regards
very nice! can you make a refrigerator analysis video?
Thanks, I will try friend.
Best regards
مرسی
thank you four your sharing, ı have a question how can ı calculate here bend factor(Kl) to find pressure loss, ı am try solving with hand too.
Kindly request sir please make one vedieo for nonlinear analysis vedieo and bucking
Thanks, I will try friend.
Best regards
Hello sir. Thank you for this video. I had 1 doubt. How is the air flowing through the pipe when the pipe is not made hollow in the geometry?
Hi friend;
In this case the fluid is water and there are three hollow (2 inles and 1 outlet).
is there any simulation tutorial where two different liquids injected into two different inlets? foe example, water injected into inlet1 and blood injected into inlet2. is it possible?
th-cam.com/video/HDMY3LOEez0/w-d-xo.html
@@ansys_cfd Thank you so much!!
I am trying to change element size but it is again set to default element size.
Hi! if i need to the solid rotate, which parameter i must change?
There is a option to rotate in the Task bar