Eurorack Noise Jam 20 - Rings, FINALLY!

I finally rebuilt the Rings module I blew up... or really, I rebuilt it from scratch. ¯\_(ツ)_/¯
Non-DIY modules:
Doepfer A-119 Ext. In., A-132-3 DVCA
Make Noise Maths
Recovery Effects Bad Comrade
DIY modules:
Zlob Triple Cap Chaos, Entropy, Entropy Expander, Diode Chaos
Befaco Muxlicer, Mex, Hex Mix VCA, Dual Atenuverter, KickAll, VC ADSR, STMix, Output v3
Nonlinear Circuits Divide & Conquer
not-Mutable Instruments DIY Ripples (v1), DIY Rings
uO&C (micro Ornament & Crime)

[@AnalogShell]

Sounds good again, how did you blow it up LOL? 😄Nice selection of Zlob stuff, so awesome for generative ❤‍🔥

[@mtodead]

My first STM32 microprocessor had two circular markings on it on opposite corners - a larger one and a smaller one. I thought the larger one was the pin 1 marking, but it wasn't, so I had soldered it in upside-down. It powered on okay, it just didn't work. Once I realized it was the wrong way, I spent 3 hours trying to desolder a 64-pin chip with an iron and some desoldering wick. It did not work. By the time I had bought a hot air reflow station, I think the chip and/or the pads were already ruined, but I didn't realize it. Once the chip was oriented correctly, when I powered it on, the resistor at R2 popped with smoke coming out, and I think it also cracked the MCP6002 op amp.

[@AnalogShell]

@@mtodead Oh god, see that's why I don't even try, I would burn my house down! Respect for keeping at it! 👊