Soft soldering of copper pipes and fittings - How To - PL

Polish Comment in this video.
See how to solder copper pipes and fittings.
We must always take care of details, everything must be thoroughly cleaned.
If you make 3 trial soldering, you will understand the whole process. The soldering point can not be overheated, when the pipes and fittings are heated, the solder is applied to the joint and is soaked to the entire surface between the fitting and the pipe where the paste is applied and the end is applied. We do not use wet rags or we do not put hot items into water.
Only after 2-4 minutes can you cool the damp rags to cool off.
How much solder should be imposed? Approximately the length of solder should correspond to the diameter of the pipe. After a few tries you will gain experience in the matter of selecting the quantity of soft solder for a given connection.
All work is extremely simple, but be careful not to burn yourself or burn yourself.
Please comment under the film whether the film was liked and whether you have any comments or good advice.
I invite you to subscribe to the ForumWiedzy.pl of the ForumWiedzy.pl and to the likes of the Forum on Facebook, so you will always be up to date.