Land Rover parking sensors not working... Fault finding and repair.

แชร์
ฝัง
  • เผยแพร่เมื่อ 17 ม.ค. 2025

ความคิดเห็น • 72

  • @beluxauto5968
    @beluxauto5968 3 ปีที่แล้ว +6

    I silently laughed when you said let´s see how to remove the sensors . All kidding aside , I have never swapped or had 3 sensors fail at the same time . Good that your client has parts on hand .

  • @Hoinar9
    @Hoinar9 3 ปีที่แล้ว +3

    Thanks, i have learn something new today.

  • @va7052
    @va7052 3 ปีที่แล้ว +12

    Problems never ends on a Land Rover

  • @engeneer_ru5827
    @engeneer_ru5827 3 ปีที่แล้ว +2

    Thank you Louis! Useful video.

  • @Parknest
    @Parknest 3 ปีที่แล้ว +1

    I've had to do the the same job on my Volvo XC90 and the rear bumper has to be removed to get to the sensors like on the Disco 3. I had a faulty sensor. The one I bought on Amazon was the wrong part so I ended up getting a used genuine Volvo sensor on eBay and it fixed the problem.

  • @nicolasdakota103
    @nicolasdakota103 ปีที่แล้ว +1

    Great job, and I hope I can fix my problem . My landrover is moody and sometimes won't crank, and radio + ac and heat don't work .parking sensor flashing

  • @kevinpalmer7452
    @kevinpalmer7452 3 ปีที่แล้ว +2

    Brilliant as always 👍

  • @electronic7979
    @electronic7979 3 ปีที่แล้ว +2

    Very good 👏

  • @HCrossland-uu7po
    @HCrossland-uu7po 4 หลายเดือนก่อน +1

    Im new to range rovers and the one I've bought has parking sensor light flashing. How much does it cost for replacement sensors?

    • @LMAutoRepairs
      @LMAutoRepairs  4 หลายเดือนก่อน

      Depends on how many sensors need replacing, where you buy them from, and who does it...
      Also, even though the sensors are the most common failure, you need to investigate first, in case it is something else...
      👍👍👍

  • @candrevajonathan-matic6604
    @candrevajonathan-matic6604 3 ปีที่แล้ว +1

    Nice engineer bro

  • @pdmark311
    @pdmark311 2 ปีที่แล้ว +3

    Super easy fix. Turn it on and put your ear up to each and you will hear a ticking sound from each beeper. If you don't hear anything that is the bad one.

    • @LMAutoRepairs
      @LMAutoRepairs  2 ปีที่แล้ว +1

      That's another way...
      The only issue with some systems, is that if is detected that one sensor is faulty, the whole system is disabled... stopping activating the remaining good ones...
      But yes, loads of systems you can do it that way...
      👍👍👍

    • @iantomlinson2422
      @iantomlinson2422 2 ปีที่แล้ว +1

      came here to say that, i have a faulty front one on my 2006 hse, thats exactly how i found it

    • @LMAutoRepairs
      @LMAutoRepairs  2 ปีที่แล้ว +1

      👍👍👍

  • @Hybriddiag
    @Hybriddiag 3 ปีที่แล้ว +2

    Muitos caros estao a churar que nao apanhao doutor como doutor luis😄

  • @panikognito460
    @panikognito460 2 ปีที่แล้ว +1

    Hi, what kind of diagnostic tool do you use?

  • @rezan_erdem
    @rezan_erdem 2 ปีที่แล้ว +1

    hello, my freelander car parking sensor eye was broken, I changed it, now there is a sound in all of them, but it still gives an error, can we reset it or what could be the problem, thank you

    • @LMAutoRepairs
      @LMAutoRepairs  2 ปีที่แล้ว

      No resetting procedure that I am aware of...
      You most likely have other issues...
      Scan the car, and see what is reporting...
      👍👍👍

    • @rezan_erdem
      @rezan_erdem 2 ปีที่แล้ว +1

      @@LMAutoRepairs When I take a video with the phone, there is a sound from the sensors, what else could it be, thank you

    • @LMAutoRepairs
      @LMAutoRepairs  2 ปีที่แล้ว

      Again, scan the car... there is a few possibilities, anything I would suggest would be pure guess work...
      A scan should point you in the right direction...
      👍👍👍

  • @yallatripoli8555
    @yallatripoli8555 11 วันที่ผ่านมา +1

    Hello i check my sensors LR3 2006 from rear and all sensors are working but i still have flashing and not working

    • @LMAutoRepairs
      @LMAutoRepairs  11 วันที่ผ่านมา

      🤔
      Have you scanned the module to see what the issue is?
      👍👍👍

    • @yallatripoli8555
      @yallatripoli8555 11 วันที่ผ่านมา +1

      @@LMAutoRepairs nop ill scanner it to see i find an errors

    • @LMAutoRepairs
      @LMAutoRepairs  11 วันที่ผ่านมา

      @yallatripoli8555
      👍

    • @yallatripoli8555
      @yallatripoli8555 10 วันที่ผ่านมา +1

      @@LMAutoRepairs i see the problem in the scanner
      The problem is from the speaker
      Thank you so much 🙏🏻

    • @LMAutoRepairs
      @LMAutoRepairs  10 วันที่ผ่านมา

      @yallatripoli8555
      👍👍

  • @jed7200
    @jed7200 2 ปีที่แล้ว +1

    Hi, I had parking aid unavailable. Faults were all 4 back sensors (one of them said historic the others said intermittent). Replaced the historic, sensor that seemed to be playing up. Problem still remains. Scanned again, now says a different sensor and control module. Wiring on one sensor looks frayed. Replace wiring look next?

    • @LMAutoRepairs
      @LMAutoRepairs  2 ปีที่แล้ว

      I would say proper check/measure wiring, repair or replace...
      👍👍👍

    • @jed7200
      @jed7200 2 ปีที่แล้ว +1

      Replaced wiring harness and rear sensors, fault still remains and without parking aid :(

    • @LMAutoRepairs
      @LMAutoRepairs  2 ปีที่แล้ว

      Stop replacing parts without actually diagnose what is wrong...
      A waste of time and money...

    • @jed7200
      @jed7200 2 ปีที่แล้ว +1

      @@LMAutoRepairs what other diagnostic is there? Codes have been read and report same thing, rear left sensor fault. Main dealer?

    • @LMAutoRepairs
      @LMAutoRepairs  2 ปีที่แล้ว

      Have you measure the wiring from the sensor to the module?

  • @neilfrancis3013
    @neilfrancis3013 3 ปีที่แล้ว +1

    Hi mate I have the same flashing light but my sensors all seem to work they all make a clicking but I have no beeping sound frome inside any idea?

    • @LMAutoRepairs
      @LMAutoRepairs  3 ปีที่แล้ว +1

      A wiring issue?
      It is difficult to say...
      Scan the car and go from there!
      👍👍👍

    • @bpatriota
      @bpatriota 2 ปีที่แล้ว +1

      Mostly like the speaker inside the trunk. Had to replace mine on my LR3

  • @mmario8423
    @mmario8423 2 ปีที่แล้ว +1

    Hello, i have a similar problem, my sensors do not work in range rover sport 2009, they do not click and do not come on when reverse or button is on, moreover light on the button is still on and button do not react.
    I cannot connect it via the diagnostic equipment, computer just do not show this module for cumminicate.
    Can you help ?

    • @LMAutoRepairs
      @LMAutoRepairs  2 ปีที่แล้ว

      Check fuses to start with...
      If all good, check powers and grounds at the module... then communication lines...
      👍👍👍

    • @mmario8423
      @mmario8423 2 ปีที่แล้ว +1

      @@LMAutoRepairs all of these has been already checked, can lines at the module are 2.9V, other are 12V and ground is also good, i have checked it on 2 modules

    • @LMAutoRepairs
      @LMAutoRepairs  2 ปีที่แล้ว

      OK...
      The voltage at the CAN lines can be deceiving... scope would be better... if you have power and grounds, and communication lines are good at the module, that leaves a bad module as the issue...

  • @louievdub8821
    @louievdub8821 2 ปีที่แล้ว +1

    any other way to change the sensor without removing the bumper

    • @LMAutoRepairs
      @LMAutoRepairs  2 ปีที่แล้ว

      Don't thing so.. unless you have really tiny and thin arms...
      To be fair, is quite straight forward, the removal of the bumper...
      Thank you for watching!👍👍👍

  • @andrewyeo2353
    @andrewyeo2353 3 ปีที่แล้ว +4

    Guessing it's cheaper to buy second hand bumper with sensors than to buy three original sensors

    • @LMAutoRepairs
      @LMAutoRepairs  3 ปีที่แล้ว +2

      😅
      Indeed!...
      👍👍👍

  • @Fabi....
    @Fabi.... 3 ปีที่แล้ว +3

    🙋‍♂️👍

  • @joshchatwin1517
    @joshchatwin1517 4 หลายเดือนก่อน +1

    Mines just started doing this

  • @mantenimientosyquimicoscan3455
    @mantenimientosyquimicoscan3455 หลายเดือนก่อน +1

    Hola mis sensores funcionan bien. Pero se dejo de escuchar el pitido dendro del coche. Quien me piede ayudar

  • @mrgrumpy5116
    @mrgrumpy5116 3 ปีที่แล้ว +1

    😊👍

  • @serolunarrosa
    @serolunarrosa 3 ปีที่แล้ว +2

    Hi, sorry I'm writing here, I swap cluster on mercedes w203 with cluster w209, now the problem is on cluster w209 don t show milege but everythink works, the quastion is can you add the milege from w203 cluster to w209 cluster, or maybe virginise the w209 cluster and coding , thank you, wait you reapond. I can come to you for me is no problem.

  • @mothanagharbe513
    @mothanagharbe513 3 ปีที่แล้ว +1

    hello

  • @mechtrev7626
    @mechtrev7626 3 ปีที่แล้ว +1

    I presume you are earning a living by repairing vehicles from home by your comments that a customer brought you a bumper to remove sensors from. I do hope that you have your premises registered as a business and that you are paying business rates on the premises

    • @LMAutoRepairs
      @LMAutoRepairs  3 ปีที่แล้ว

      No I not earning a living from this...
      I have a job... this is a part time only...
      Thank you for watching!

    • @eArtrash
      @eArtrash 14 วันที่ผ่านมา

      How about you mind your own business? Corporate bootlicker