Golf Mk1: Accelerator Cable adjustment

แชร์
ฝัง
  • เผยแพร่เมื่อ 26 ส.ค. 2024
  • VW Golf Mk1 .Ensure correct Accelerator Cable adjustment #mk1golf

ความคิดเห็น • 14

  • @mfc4591
    @mfc4591 24 วันที่ผ่านมา

    Helpful because I need to replace the cable soon.

  • @Tutterzoid
    @Tutterzoid 11 หลายเดือนก่อน +1

    Thanks Boet :)

  • @damoncarter1223
    @damoncarter1223 11 หลายเดือนก่อน

    Hi, please will you make a video on how to wire the rev counter

  • @dannyslota98
    @dannyslota98 11 หลายเดือนก่อน +1

    Can you make video about the coil,module my module keeps dying don't knw why?

    • @PhillyJr3
      @PhillyJr3 11 หลายเดือนก่อน +1

      Had the same issue recently, had to see if my rotor and distributor are stil good and realised they were exhausted and needed to be replaced then my problem was solved after 3 coils died brand new

  • @chadkramer9684
    @chadkramer9684 11 หลายเดือนก่อน

    Hi PJ when I accelerate from a stop I have to feed it smoothly than I can push my foog down, otherwise if I tramp the accelerator down immediately it jerks

    • @pjs-golfmk1-diy
      @pjs-golfmk1-diy  11 หลายเดือนก่อน

      Sometimes that can be a weak spark plug or a bad spark lead
      It can also be an air leak, at base plate ,or servo pipe.
      Check even your ignition timing ,and the vacuum advance on the distributor ,and the little pipe that runs from it to back of carb
      I have videos on these topics ...just search on the channel.

  • @someonespecial3277
    @someonespecial3277 11 หลายเดือนก่อน

    Howzit, My golf mk1 doesn't idle, to keep the car running you either have to keep your foot on the accelerator or keep the choke up, base plate was changed, carb was cleaned and tuned according to your carb tuning video. Ground connections are fine and idle cut off valve works and there is enough fuel going to the carb. I still don't know what the issue is.pls help😅

    • @pjs-golfmk1-diy
      @pjs-golfmk1-diy  11 หลายเดือนก่อน

      Hi
      Have you checked for air leak at the servo pipe yet . I have a video on that ..

    • @someonespecial3277
      @someonespecial3277 11 หลายเดือนก่อน

      Servo pipe is new

  • @DanielCraig-uj2jj
    @DanielCraig-uj2jj 11 หลายเดือนก่อน

    Hi Pj can a stiff cable cause i high ref in other gears like 2 second wen u remove ur foot of the accelerator quickly

    • @pjs-golfmk1-diy
      @pjs-golfmk1-diy  11 หลายเดือนก่อน

      Hi.
      Yes exactly...just give the cable bit of slack to test it

  • @user-tx2sw5zv4u
    @user-tx2sw5zv4u 6 หลายเดือนก่อน

    Hai wht makes idling high

    • @raduszilagyi6055
      @raduszilagyi6055 3 หลายเดือนก่อน

      When adjusting my cable I tightened it too much and the car was idling at around 1300-1400 RPM. I loosened it, and then fine tuned it until it idles normally at around 5-600 RPM.