6.0L LS LQ4 swap to a 4 speed Muncie SM465 MANUAL TRANSMISSION square body Chevy K20 Silverado

what parts to use.
Hays 91-1004 Street 450 Clutch Kit
amzn.to/46ZOn2V
Speedmaster 1-229-015 Fits Chevy LS1 LS2 LS3 LS6 LS7 L76 168 Tooth DNA® Billet SFI Flywheel
amzn.to/454RpRJ
Chevrolet Performance 12557583 Bearing - Clutch Pilot
amzn.to/3Odh4R4
ARP 1342201 Hex Pressure Plate Bolt Kit
amzn.to/43GGUCT
Chelhead LS Flywheel Locking Tool Steel Black Oxide Flexplate Locking Holder Tool Compatible with Engine Chevy LS 1 2 3 LSX
amzn.to/3O6CNdD

[@alimys5737]

doing good job keep it up

[@papergatorzfedducca7998]

New subscriber bro🔥🔥🔥

[@bradleycrenshaw6778]

Thank you so much.

[@ricardoceballos7469]

Great video 💯! What is the part number for those flywheel bolts ?

[@brandonogier4066]

When putting engine in did you have to do anything for oil pan clearance

[@markcarlile7380]

Have you ran the set up yet with that pilot bearing and if so have you had any issues Or further recommendations

[@markcarlile7380]

Does the stock sm465 bell housing bolt to the ls

[@johnmilner7603]

And don’t forget to use brake clean on the flywheel before installing the clutch disc. Finger prints and grease on the flywheel will make your clutch chatter.😂

[@davidgoucher7177]

who tuned your pcm and did you have to have a VSS?

[@KCStrain]

Were you able to bolt it to the ls while using the factory input shaft and small block chevy bellhousing on the muncie?

[@JCustomFab]

Yes, a bolt's right up. The only thing you need to do is get the right bushin or bearing for the input Shaft ride on. But you definitely have to get the right fly. Wheel and a stock clutch and pressure plate will bolt to it

[@troymatthews9592]

Did you use a swap oil pan or did you make the aftermarket pan work?

[@JCustomFab]

I did use the stock truck ls oil pan As long as you got a two inch or bigger lift

[@77_squarebodyC30]

What are you using for throw out bearing/slave cylinder?

[@JCustomFab]

th-cam.com/video/XTAUPHj-qYo/w-d-xo.htmlsi=PJtGJuoUO4sANG1x check this video out.

[@markcarlile7380]

What year LQ4, and can you explain how the ALL26112 spun on the shaft, I’m confused, I know the the 6.0 LS had two different size shaft the pilot rides on based on the generation, I’m currently doing this swap with a 2002 LQ4 into a 1978 with the sm465

[@JCustomFab]

I'm not sure how it spun. But it did and when I installed it, it was Very tight. There is 2 different depths to the crankshaft on them. Depends on your output shaft.