My guy I am not sure if you did off camera but flux would help with the soldering. Although, the nickel strip should be spot welded and even though the insulation on the wires isn’t cut back yet I would still advise wrapping your wire ends with tape when soldering them on so they aren’t all freely flopping around with the potential of a short circuit.
Do I need to connect (weld, solder) batteries to the BMS board in sequence (from plus to minus or vice versa) how is it in the laptop battery so that the board does not go into protection?
How would you make 3s 2p , but flat in a line , not in a rectangle like this . so like this = = but 3 next to each other . does that make sense . like if you just had 3s
Thanks bro you showed it in a best way
Thank you sir you helped me a lot i will be grateful to you,
My guy I am not sure if you did off camera but flux would help with the soldering. Although, the nickel strip should be spot welded and even though the insulation on the wires isn’t cut back yet I would still advise wrapping your wire ends with tape when soldering them on so they aren’t all freely flopping around with the potential of a short circuit.
Muy buena orientación, Gracias por la ayuda.
Do I need to connect (weld, solder) batteries to the BMS board in sequence (from plus to minus or vice versa) how is it in the laptop battery so that the board does not go into protection?
How would you make 3s 2p , but flat in a line , not in a rectangle like this .
so like this = = but 3 next to each other . does that make sense . like if you just had 3s
Bahi
12 volt BMS may maximum kitna voltage se charge karsakte hay.
I try it 🥰
can this BMS handle back EMF from DC brushed motor ? Why i am asking is i want to power a 12V DC motor for electric drill application.
Sir, can be use to mini amps with power capacity of 12-24volts at 3 ampere?
How much maximum voltage apply in 12volt BMS ???
Cuanto mah tendría la batería?
Is this Chanel still active? I’m looking for a little help on a project and can compensate for your time thanks.
I also have the same model...can it use 18650 12 battery
Use 3S 25 or 30 Ah
كم مده الشحن ....؟
can you tel me how many volts and amps should I use to charge the batterys ?
12V 3-5A
@@letsdoitthailand 3000 الي 5000ملي امبير صح
Hi, I'm getting 8.4V out of this same model any suggestion?
Sip
como se la conecta para cargarla?
10 A ????????
Skema nya....
Can I connected 9 batteries like this?
No, the pcb is only for lithium ion batteries
This bms is 3S 10Ah......use 3S 25Ah with 9 batteries
3 a