Anyang Power Hammer Motor Guard - Cut on forge made CNC Plasma Cutter

Keep an eye on our channel for more content and if you would like any more information about any other products we make and sell please get in contact with us on 01362687116 or email us at [e-mail]
www.forged-iro...
www.artist-blac...
Thanks for watching!

[@34428]

I am mightily impressed by the cnc Nigel. Quite an achievement.

[@NigelBarnettArtistBlacksmith]

thanks Mark
its well paid for.

[@tokolosh11]

Nice informtive video as always Nigel. We seem to have a lot of the same gear... only you have a heck of a lot more and bigger. 😁 I have an Avid cnc plasma table also with a water table and an XP45. I used to do garden signs and the like so it was fine for my needs. I have cut 10mm plate quite easily with it, although not on the finecut consumables and a tad slower. I made my motor guard out of 3mm plate bent up and bolted to the motor mounts. Just in case the motor needs to be removed.

[@NigelBarnettArtistBlacksmith]

Hi Anthony i can lift the motor out with the guard on as we made it tail so you can do so .most of my work is big so i dont have to compete with garden shed blacksmiths with no overheads that way i can give my small work to them and they give there big work to me and we all survive .

[@NigelBarnettArtistBlacksmith]

hi again just a pointer mix a big bag of borax in your water table it stops it going stinky and is cheaper that the right stuff .we was creating life in ours as it is a plasma being fired into water and bugs were living in it and it smelt bad.

[@tokolosh11]

@@NigelBarnettArtistBlacksmith Thanks for that tip. Up to now I have used the "store bought stuff". Which is kind of expensive.

[@NigelBarnettArtistBlacksmith]

borax for our tank was only £30 for a massive bag and it lasts forever .