How to do a Module Scan on Paradox Alarm EVO48, EVO192, EVOHD, 3Ways

[@mitchelldynamix5405]

Thank you. I’m new at this.

[@JasonTech]

You’re welcome!

[@MrAsafalfa]

For me it didnt help much i had to use the 400 -> then select zone number and add manually according to the ID of each detector...
May i ask what should you do if out of 15 zones you ahve 2 that stay always open ?
How can i understand why ?

[@JasonTech]

What panel model do you have?

[@MrAsafalfa]

​@@JasonTech I appreciate your first response.
I have a TM70 with evoHD, and the motion detector is an NVx80; I tried switching it out with another one, but the result was the same.
If you know how I can stop this and see when it triggers like any other typical detector, that would be wonderful. I'll add this to all my NVX80 display Setting menu.
By the way, I did everything myself because I do DIY.

[@JasonTech]

There is 2ways to set this up this motion. How did you hook it up? Are you using the bus or zone?
Did you replace this with another motion?

[@MrAsafalfa]

@@JasonTech Good questions :) -> so i installed it using the BUS, and yes i did try to replace it with another motion and redo the Full scan and manually attach it using S.N

[@JasonTech]

Ok, try this first, remove the green & yellow and put the green in COM and the yellow in NC.

[@nathanruben3372]

Does tm70 worth buying. It as expensive as the panel itself.

[@JasonTech]

It a nice keypad but it comes down to, Do you need it?