Tell me, please, the tightening torque of the cylinder head, so as not to break the thread, what is the distance of the thermal gap between the piston and the head? Thanks yamaha raptor 350
You need to learn how to install the rings on the piston, you shouldn't open both ends of the ring and force it on. You start with one end and walk it round.
![ALLY - OH MY! [ REACTION ] 'Amarin Nitibhon' #ALLY_OHMY #ALLY #allynitibhon #แอลลี่](http://i.ytimg.com/vi/nX9qpHjVfbQ/mqdefault.jpg)
You supposed to push on ring with piston before checking gap to get good square fit
Lube lube lube. That wristpin bushing probably got smoked on startup. Great job on build, just need to use that lube. 👍
Does the wrist look bushing (the bronze part one in the rod) does it spin? (Mine does)
When you were measuring the piston ring end gap was the 0.20 to 0.40 in thousands of an inch
I think so , hard to remember this was over a year ago you might have to check a Manuel
Ok thank you 👍
Did you have to pull the head back off and reposition that timing chain guide?
Tell me, please, the tightening torque of the cylinder head, so as not to break the thread, what is the distance of the thermal gap between the piston and the head? Thanks yamaha raptor 350
Are the head bolts all the same or do you have to put them in the right spots
What was the compression for the piston I’m getting ready to put a 11:1 in mine
I think that is what it was
Super 👍
It would be helpful to lube the bolts before install and torquing
Thanks for the advice!
@@vrr6513 thanks for showing the timing marks as I might be working on one of these
Not lube. Antiseize. Its not the same thing. If you lube it it can come loose.. you should clean bolt threads and put on some antiseize.
You need to learn how to install the rings on the piston, you shouldn't open both ends of the ring and force it on. You start with one end and walk it round.
Thanks for the advise!
Do not listen to this he’s not pre lubing nothing sir you need to start video with disclaimer
everthing was prelubed apon assembly
@@vrr6513 no it’s not clear in video you used no lube on piston at all putting on rod bam dry start
It’ll be ok😂 if you gonna bitch then make your own video